Custom Setup; Audio Setup - Sony DVP-SR200P Reference Manual

BLACK LEVEL: Selects the black level (setup
level) for video signals output from the jacks
other than COMPONENT VIDEO OUT.
BLACK LEVEL (COMPONENT OUT):
Selects the black level (setup level) for video
signals output from the COMPONENT VIDEO
OUT jacks.
PROGRESSIVE (COMPONENT OUT
2
ONLY)* : Set to "ON" if your TV accepts
progressive format signals. When you select
"ON," set also the following "MODE
(PROGRESSIVE)" and "4:3 OUTPUT."
MODE (PROGRESSIVE): If you select
"AUTO," the player detects the format (film-
based or video-based), and converts to the
appropriate version.
4:3 OUTPUT: This setting is effective only
when you set "TV TYPE" to "16:9." Select
"FULL" when you can change the aspect ratio
on your TV.

CUSTOM SETUP

AUTO PLAY: When set to "ON," the player
automatically starts playback when the player is
turned on by a timer (not supplied).
PAUSE MODE: Selects the picture in pause
mode. Normally select "AUTO." When the
picture is output in high resolution, set to
"FRAME." (DVD only)
TRACK SELECTION: Gives the sound track
which contains the highest number of channels
priority when you play a DVD VIDEO on
which multiple audio formats (PCM, DTS, or
Dolby Digital format) are recorded. If you
select "AUTO," priority is given. (DVD
VIDEO only)
MULTI-DISC RESUME: Switches the Multi-
disc Resume setting on or off. Resume playback
can be stored in memory for up to 6 different
DVD VIDEOs/VIDEO CDs. If you start the
settings again, the resume point is cleared.
(DVD VIDEO/VIDEO CD only)
8

AUDIO SETUP

AUDIO DRC (Dynamic Range Control)*
Set according the surrounding environment. Set
to "TV MODE" when the smallest sounds are
indiscernible, or set to "WIDE RANGE" when
the listening environment is good, for example,
in a home movie theater.
3
DOWNMIX* : Switches the method for
mixing down to 2 channels when you play a
DVD which has rear sound elements (channels),
or is recorded in Dolby Digital format.
Normally select "DOLBY SURROUND."
DIGITAL OUT: Selects if audio signals are
output via the DIGITAL OUT (COAXIAL)
jack. When you select "ON," set also the
following "DOLBY DIGITAL," "DTS," or
"48kHz/96kHz PCM."
DOLBY DIGITAL: Selects the type of Dolby
Digital signal. Set to "D-PCM" when the player
is connected to an audio component without a
built-in Dolby Digital decoder.
DTS: Selects the type of DTS audio signal. Set
to "ON" when you play a DVD VIDEO with
DTS sound tracks. Do not set to "ON" when
you connect the player to an audio component
without a DTS decoder.
48kHz/96kHz PCM: Selects the sampling
frequency of the digital audio output signal.
(DVD VIDEO only)
1
* When you select "OTHERS t," select and
enter a language code. See "LANGUAGE
CODE LIST" at the end of this manual.
2
* If the picture does not appear normally or goes
blank, reset the setting. Press [/1 to turn off,
enter "369," and then press [/1 to turn on the
player again.
3
* This function affects the output from the
following jacks:
– AUDIO OUT L/R jacks.
– DIGITAL OUT (COAXIAL) jack only when
"DOLBY DIGITAL" is set to "D-PCM."
3
: