BRP Ski-Doo COMPACT DIGITAL DISPLAY Operator's Manual page 22

E E - - T T E E C C E E N N G G I I N N E E
To engage procedure, do the following:
1. Place the vehicle in a well ventilated area.
2. Start the engine and let it run at idle speed until it reaches its oper-
ating temperature (watch the coolant temperature on the display or
verify the rear heat exchanger becomes warm).
3. Press and release the mode button on the gauge until the odome-
ter is displayed on the lower display.
1. Gauge mode button
N N O O T T E E : :
The storage mode does not function in other modes (trip A, trip B and
hr trip).
4. While holding the mode button on the gauge, rapidly switch from
HIGH to LOW beam until the gauge displays P P R R E E S S S S / / H H O O L L D D B B U U T T - -
T T O O N N F F O O R R O O I I L L I I N N J J E E C C T T I I O O N N .
5. Release all buttons.
6. Again, press and hold the mode button for 2 - 3 seconds.
7. When gauge displays O O I I L L , release button and wait for the lubrica-
tion function to end.
Do not touch anything during engine lubrication cycle.
The engine lubrication function takes approximately 1 minute. Dur-
ing this time the engine RPM will increase slightly to approximately
1600 RPM and the oil pump will "oil flood" the engine.
At the end of engine lubrication procedure, the ECM will turn the
engine off.
20