Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL T-MS 3,6 Original Operating Instructions

Anleitung_T_MS_3_6_SPK7:_
Important.
The handle may become a little warm during the
charging process. This is normal. If the battery pack
fails to charge, please check
whether there is voltage at the socket-outlet
whether there is good contact at the charging
contacts in the battery charger
If the battery still fails to charge, please contact the
service center. You will find the contact data in the
enclosed warranty booklet.
Timely recharging of the battery will help it serve you
well for a long time. You must recharge the battery
pack when you notice that the performance of the
equipment drops.
Warning! Under no circumstances should you open
the housing. If you discover any damage to the
housing, do not use the battery charger any more. If
the equipment is damaged, contact your supplier or
the manufacturer.
6.2 ON/OFF switch (Fig. 2)
To switch on:
Press the locking button (2) and the ON/OFF switch
(1) at the same time
To switch off:
Release the locking button (2) and the ON/OFF
switch (1) at the same time
6.3 Changing the cutting attachment (Figure 3)
Important. The blade on the cutting tool is very
sharp.
You can fit or replace the cutting attachment without
using any other tools. Press in the locking knobs (4a)
on the right and left side of the cutting attachment (3).
At the same time use the other hand to push the
locking knob (4b) on the cutting tool upwards and
then pull the cutting attachment (3) away to the front.
To fit the cutting attachment (3), push it into the guide
(a) at the front and press it to the rear until it latches in
place. Check that the cutting attachment (3) is
secure.
6.4 Notes on operation
Never subject the equipment to so much load that
it stops working.
The equipment's cutting performance depends
on the material being cut and the charge status of
the battery.
Depending on the charge status, too high a feed
24.08.2011 8:48 Uhr Seite 43
speed of the equipment will reduce the
equipment's performance dramatically.
The cutting blade must always be kept free and
clean.
Make sure that no thin materials such as textiles
are drawn into the equipment and jam. Do not
press the equipment too firmly against the
material; always hold the material under tension.
For optimum cutting results, carry out trial cuts on
test pieces.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
out with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Please contact the service center. You will find the
contact data in the enclosed warranty booklet.
GB
43