Table Of Contents - NAVAC MASTER Series User Manual

Empowering you to work smarter
TABLE OF CONTENT
General Safety .......................................................................................................... 1
Operation ................................................................................................................ 3
Specification ............................................................................................................. 5
Introduction of Operation Panel .................................................................................... 6
Parts Diagram ........................................................................................................... 7
Wiring Diagram ......................................................................................................... 8
Operating Instruction
1). Refrigerant Hoses Exhaust .................................................................................
2). Recovery Mode .............................................................................................. 1 O
3). Pur g e Mode ................................................................................................... 11
4). Liquid Push/Pull Mode ..................................................................................... 12
Trouble Shooting ...................................................................................................... 1 3
N.AYf.AC
Empowering you to work smarter
GENERAL SAFETY
Use information
■
In order to prolong the life cycle of the recovery unit, please read the manual carefully before using to fully
understand the safety, specification as well as operating procedure of the recovery unit.
■
Please check the product received is same as you ordered.
Please check the product if there is any damage during transpcrtation.
Contact with local distributor if the above problem is found.
■
Please read the manual carefully and use the unit according to the product operating procedures.
Safety indication
A warning
This mark indicates procedures that must be strictly observed to prevent hazards to people.
A Notice
9
This mark indicates procedures must be strictly observed to prevent damage or destruction of the unit.
Matters needing attention
Awarning
Only a qualified tech nician should operate this recovery unit.
Before starting the equipment, make sure that it is well grounded.
If using electrical extension cord, the cord must be in good condition and properly connected and
grounded.
The power must be cut off and no display in LCD before inspecting or repairing.
If the original power supply cord is damaged, an OEM replacement may be ordered through your NAVAC
distributor.
Only a qualified person may replace the cord according to local codes and standards using OEM
wiring diagram
N.AYf.AC
01