Advertisement
EN
OUTDOOR UNIT FORMWORK KIT L01070II - L01071II - L01072II
Warnings
This instruction is an integral part of the booklet of the ap-
pliance on which is installed. Please consult this booklet
for general warnings and fundamental safety rules.
Standard supply
The outdoor unit formwork kit for the built-in installation IN
and partial built-in installation PI consists of:
• 1 backrest
• 1 upper metal sheet
• 1 lower metal sheet
• 2 side metal sheets
• 3 supporting frame brackets
1.
Backrest
2.
Upper metal sheet
3.
Side metal sheet
4.
Lower metal sheet
2
1
3
4
Match
Combination of outdoor unit formwork kit for installation of
built-in version IN and partial built-in version PI:
• 2 upper side brackets
• 2 upper centre brackets
• 2 tracks
• fixing screws
5.
6.
7.
8.
3
6
7
8
5
• L01070II - for models 5M, 7M
• L01071II - for models 9M, 11M, 11T
• L01072II - for models 13M, 13T, 15M, 15T
For a rapid and right assembly of the components follow
carefully the sequences described in the various sections.
All the operations must be performed by qualified person-
nel using the required Personal Protective Equipment.
The formwork arrives disassembled, to be assembled dur-
ing installation.
Supporting frame brackets
Upper side brackets
Upper centre brackets
Tracks
N420529A
Advertisement
Table of Contents
Summary of Contents for Stone L01070II
- Page 1 N420529A OUTDOOR UNIT FORMWORK KIT L01070II - L01071II - L01072II Warnings This instruction is an integral part of the booklet of the ap- For a rapid and right assembly of the components follow pliance on which is installed. Please consult this booklet carefully the sequences described in the various sections.
- Page 2 N420529A Formwork dimensions and weights Model 5 - 7 1089 1056...
- Page 3 N420529A Model 9 - 11 1342 1310...
- Page 4 N420529A Model 13 - 15 1539 1506...
-
Page 5: Installation Site
N420529A Reception Preliminary warnings No notice of damage will be accepted after 3 days from delivery. Upon receipt of the package check that it is not damaged, Package description otherwise accept the goods with reserve, producing pho- tographic evidence of any damage. The packaging is made of suitable material and carried out by experienced personnel. -
Page 6: Component Assembly
N420529A • solar radiation and proximity to heat sources • the section of floor or wall does not involve load-bearing construction elements, piping or electrical lines Avoid placing the unit within 1 metre of radio and video • the appliance must be installed in a position where it can equipment. - Page 7 N420529A Backrest and frame Backrest Upper metal sheet Side metal sheet Lower metal sheet...
-
Page 8: Supporting Frame
N420529A Supporting frame Remove the formwork support frame only when installing the unit. - Page 9 N420529A Accessory Upper side brackets Upper centre brackets Tracks...
-
Page 10: Installation
N420529A Installation Connections The kit can be installed in the vertical position only. Polyethylene formwork insulation, 5 mm thick. When positioning the appliance, prepare the wall to house the formwork. The formwork is supplied with anchor bolts to anchor the formwork to the wall.
Need help?
Do you have a question about the L01070II and is the answer not in the manual?
Questions and answers