Corbin HD-FLH-9-S Instructions

Part Numbers:
Description:
Solo Saddle & Pillions
Fitment:
2009 Harley-Davidson Roadking & Streetglide
Revision:
1
Tools Required
2 7/16" socket or combination wrench
10mm open wrench
Phillips screwdriver
1/2" open wrench
1. Begin by removing your stock seat. If you have
the seat heater option, remove the left side cover from
the motorcycle, providing access to your fuse box.
Refer to your owners manual if necessary.
2. If you are installing a NON-heated seat, skip to
step 10. Otherwise your Corbin saddle comes
prewired with the switch, heating elements and
controller already in place on the saddle. The only
special installation required is to wire the appropriate
adapter to the quick release pigtail into your fuse box
and connect it to the seat.
3. Installing the pigtail is simple and only requires two
connections. The red wire will plug into the accessory
jack of your fuse box, while the black wire connects to
the ground location on the battery.
4. The fuse box is located on the left side of your
motorcycle under the side cover. Open the fuse box
cover and locate Accessories fuse. Remove the
Accessory fuse (check inside of fuse box cover or
owners manual for it's location). Insert it into the open
slot in the fuse adapter (Figure 1), then return it to the
original accessory fuse slot in the fuse box (Figure 2).
NOTE: You may need to bend the prongs slightly on
the fuse adapter to get a better fit (Figure 3).
HD-FLH-9-S, HD-FLH-9-50S, HD-FLH-9-5-TP
HD-RK-9-S(E)
FRONT SADDLE:
1 #A00525 Rear fender bracket
1 #SP11015 Latch Pin
2 1/4 x 20 NyLock nuts (SP00123)
4 6mm flat washers (SP01080)
1 6mm nylock nut
REAR SADDLE:
1 #P10114 Latch pin
1 #P00545 Nylon cap
ELECTRIC OPTION:
#FACC-05 Small Fuse Adapter
#Ph-CB-HL Wiring Harness
1 Mini Fuse 7.5 Amp
3 Zip ties
FIG 1
FIG 2
Parts List