Table of Contents
Advertisement
2.4
Installation of drivers
Keep the necessary information from your Internet provider handy:
b
b
Plug&play installation
The MicroLink ADSL PCI supports plug&play. Plug&play simplifies the instal-
lation considerably. Windows wizards will guide you through the installation
and ask you for necessary data.
There are differences among the installation procedures for the operating
systems. Therefore, the driver installation will be described separately for
each Windows version for the sake of clarity.
2.4.1
Installation under Windows 98
If you use an Internet provider who is not listed, activate the 'Configure the
ADSL connection manually' option and enter the 'Protocol', 'Encapsulation',
'VPI' and 'VCI' settings manually. You will get the necessary information from
your provider.
Provider name and/or
Service name (e. g. DSL)
Restart your computer after inserting the PCI card.
Insert the supplied devolo product CD into your CD-ROM drive.
Windows starts the hardware wizard and reports that new hardware has
been detected. Confirm this message with Next.
Windows offers you two different ways of searching for drivers. Select
the 'Search for the best driver for your device (Recommended)' option and
click Next.
The suitable driver can be found on the devolo product CD. Activate the
'CD-ROM drive' option and deactivate all other boxes. Confirm with
Next.
The driver installation is starting. Confirm with Next to continue the
installation.
Now set up your Internet access by selecting the 'Country' where you are
and your 'Internet service provider' auswählen.
Confirm your settings with OK. The driver installation continues.
|
Installation
|
devolo MicroLink ADSL PCI
11
|
Advertisement
Table of Contents
Need help?
Do you have a question about the ADSL PCI and is the answer not in the manual?