Silhouette Professional SPRWC031D1SS Owner's Manual page 7

INSTALLATION INSTRUCTIONS
Important: Determine the fi nal location of the appliance before attempting to install
the bracket. Choose one of the three installation methods below.
Anti-tip bracket
Anti-tip bracket
Anti-tip bracket
Important: After installing the bracket, try using light force to tip the unit. If
the unit does not tip then the bracket is installed correctly. If the unit does tip,
Drywall Installation:
Flat washer
1. Place the bracket on the fl oor with mounting hole B
Lock washer
2. Use two screws to secure the bracket to the wall.
3. Ensure at least one screw is secured to a wall stud.
4. Place the unit so that the mounting hole E on the unit is
Bolt
Screw
Note: At least one screw must enter a wood wall stud. If there
are no wall studs available, use fl oor installation.
Wall stud
Wood Floor Installation:
Flat washer
1. Place the bracket on the fl oor and secure it with two
Lock washer
2. Place the unit so that mounting hole E on the unit is
Bolt
Screw
Concrete Floor Installation:
Flat washer
1. Place the bracket on the fl oor and mark the location of
Lock washer
2. Using a concrete drill bit, drill an 8mm (3/8") pilot hole
Bolt
3. Remove the nut, spring washer and washer from the
Expansion screw
4. Carefully tap the expansion screw into the drilled hole
5. Place the fl oor bracket with mounting hole D over the
6. Place the unit so that mounting hole E on the unit is
reinstall the bracket more securely.
against the wall.
lined up with mounting hole A on the bracket and secure
with a bolt, a lock washer and a fl at washer.
screws.
aligned with mounting hole A on the bracket and secure
with a bolt, a lock washer and a fl at washer.
mounting hole D on the fl oor.
45~55mm (1.7"~2") deep at the marked location.
expansion screw.
using a hammer or mallet.
expansion screw and secure with the nut, spring washer
and washer.
aligned with mounting hold A on the bracket and secure
with a bolt, lock washer and fl at washer.
6