Table of Contents
Advertisement
Quick Links
Manual for vehicle manufacturer
Model name: FOB‐4F33
OUTLINE
1. How to use FOB‐4F33
‐ FOB‐4F33 is a part of Remote Keyless System.
‐ This unit controls door lock/door unlock/trunk open/panic/remote engine start‐stop/LAMP wirelessly.
2. Introduction of Transmitter (FOB‐4F33)
‐ This unit has 5 buttons.
‐ This unit uses the battery
‐ Frequency is 433.92MHz
GENERAL DESCRIPTION
PRIMARY FUNCTION
‐ Remote door lock/door unlock/trunk open/panic/remote engine start‐stop
‐ Operating voltage: 3V DC
‐ Center freq.: 433.92MHz
Advertisement
Table of Contents
Related Manuals for Hyundai Mobis FOB-4F33
Summary of Contents for Hyundai Mobis FOB-4F33
- Page 1 Manual for vehicle manufacturer Model name: FOB‐4F33 OUTLINE 1. How to use FOB‐4F33 ‐ FOB‐4F33 is a part of Remote Keyless System. ‐ This unit controls door lock/door unlock/trunk open/panic/remote engine start‐stop/LAMP wirelessly. 2. Introduction of Transmitter (FOB‐4F33) ‐ This unit has 5 buttons. ‐ This unit uses the battery ‐ Frequency is 433.92MHz GENERAL DESCRIPTION PRIMARY FUNCTION ‐ Remote door lock/door unlock/trunk open/panic/remote engine start‐stop ‐ Operating voltage: 3V DC ‐ Center freq.: 433.92MHz...
- Page 2 MANUAL 1. LOCK Button If the LOCK button is pressed, then TRANSMITTER sends the LOCK data. 2. UNLOCK Button If the UNLOCK button is pressed, then TRANSMITTER sends the UNLOCK data. 3. TRUNK Button If the TRUNK button is pressed, then TRANSMITTER sends the TRUNK data. 4. PANIC Button If the PANIC button is pressed, then TRANSMITTER sends the PANIC data. 5. START‐STOP Button If the REMOTE ENGINE START‐STOP button is pressed, then TRANSMITTER sends START‐STOP data.
- Page 3 FCC/ISED NOTICE [FCC] This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could avoid your authority to operate this equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter unless authorized to do so by the FCC [ISED] This device contains licence‐exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence‐ exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter unless authorized to do so by the ISED Cet appareil est conforme aux limites d'exposition aux rayonnements de l’ISDE pour un environnement non contrôlé. L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne ou autre émetteur, à moins d'y être autorise par I'ISDE.
Need help?
Do you have a question about the FOB-4F33 and is the answer not in the manual?
Questions and answers