Safety Information - Pentair Hydromatic FG-3100RC Installation And Operation Manual

SAFETY INFORMATION

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This manual contains important
instructions that should be followed during installation,
operation, and maintenance of the product.
This is the safety alert symbol. When you see this symbol
on your pump or in this manual, look for one of the following
signal words and be alert to the potential for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided, can
result in death or serious injury.
indicates a hazard which, if not avoided, can or
may result in minor or moderate injury.
Note: addresses practices not related to personal injury.
Carefully read and follow all safety instructions in this manual
and on pumps. Keep safety labels in good condition. Replace
missing or damaged safety labels.
Battery acid is corrosive. Do not spill on skin,
clothing, or battery charger. Wear eye and head protection
when working with battery. Connect and disconnect DC output
terminals only after removing the charger from the AC outlet.
Never allow the DC terminals to touch each other.
Hazardous Voltage. Can cause severe or fatal
electrical shock. Do not plug in or unplug battery charger while
standing on a wet floor or in water. Be sure one hand is free
when plugging in or unplugging charger. If basement floor is
wet, disconnect power to basement before walking on floor. If
shut-off box is in basement, call electric company or hydro
authority to shut-off service to house, or call your local fire
department for instructions. Remove pump and repair or
re place. Failure to follow this warning can result in fatal
electrical shock.
Risk of flooding. Do not run pump dry. To do so
will damage seals and can cause leaking and property damage.
Risk of electrical shock. Do not lift the pump by
the electrical cord; lift pump only by the discharge pipe, lifting
ring or handle on the pump. Lifting by the cord can damage the
cord.
CALIFORNIA PROPOSITION 65 WARNING
This product and related accessories contain
chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm.Know the pump
application, limitations, and potential hazards.
1. Do not use in water with fish present. If any oil leaks out of
the motor it can kill fish. Note: This unit is not designed as
a waterfall or fountain pump, or for applications involving
salt water or brine! Use with waterfalls, fountains, salt
water or brine will void warranty.
HYD983 (06-08-20)
2. Disconnect power before servicing.
3. Drain all water from system before servicing.
4. Secure discharge line before starting pump. An unsecured
discharge line will whip, possibly causing personal injury
and/or property damage.
5. Check hoses for weak or worn condition before each use,
making certain that all connections are secure.
6. Periodically inspect sump, pump and system components.
Keep free of debris and foreign objects. Perform routine
maintenance as required.
7. Provide means of pressure relief for pumps whose
discharge line can be shut-off or obstructed. Release all
pressure within system before servicing any component.
8. Personal Safety:
Wear safety glasses at all times when working with

pumps.
Keep work area clean, uncluttered and properly

lighted – replace all unused tools and equipment.
Keep visitors at a safe distance from work area.

Make workshop child-proof – with padlocks, master

switches, and by removing starter keys.
9. Follow local and/or national plumbing and electrical
codes when installing the system. A ground fault circuit
interrupter (GFCI) is recommended for use on any
electrical appliance submerged in water.
10. Follow local and/or national plumbing and electrical
codes when installing the system. A ground fault circuit
interrupter (GFCI) is recommended for use on any
electrical appliance submerged in water.
11. All wiring should be performed by a qualified electrician.
12. This equipment is only for use on 115 volt
(single phase) and is equipped with an approved
3-conductor cord and 3-prong, grounding-type plug.
13. Where a 2-prong wall receptacle is encountered, it must
be replaced with properly grounded 3-prong receptacle
installed in accordance with codes and ordinances that
apply.
14. Make certain power source conforms to requirements of
your equipment.
15. Protect electrical cord from sharp objects, hot surfaces,
oil, and chemicals. Avoid kinking cord. Replace or repair
damaged or worn cords immediately.
16. Do not touch an operating motor. Modern motors can
operate at high temperatures.
17. Pump clear water only with this pump.
18. Pump is permanently lubricated at the factory. Do not try
to lubricate it!
19. This pump is designed for use in a residential sump only.
3