Advertisement
If a gas leak is found or suspected, immediately turn off the gas cylinder, switch the heater off and DO NOT use again until it has
9
been checked by a qualified service centre. If the heater is installed indoors, provide good ventilation by opening doors and windows
completely. DO NOT produce sparks or open flames.
Ensure the fan is operating correctly before lighting the burners.
9
If the heater has to work for a long periods at its maximum capacity it is possible that ice will form on the cylinder. This is due to
9
excessive vapour withdrawal. NEVER heat the cylinder for this or any other reason. To avoid this effect or at least reduce it use a
large cylinder or at least two cylinders linked together, see fig.1.
WARNING! Disconnect heater from mains electrical supply and gas cylinder before servicing or performing maintenance. Replace or
‰
repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience or knowledge if they have been given supervision or instruction concerning the use of the appliance
in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and maintenance shall not be undertaken by children without supervision.
9
Children of less than 3 years should be kept away unless continuously supervised.
9
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided it has been placed or installed in its
9
intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
2. INTRODUCTION
75,000 - 102,000Btu/hr (22 - 30kW) variable output (propane). Fully approved gas regulator. Features safety solenoid preventing the unit from
leaking gas without first being electrically started. Fan assisted, fitted with a piezoelectric ignition system for trouble-free starting and features a
direct gas head assembly.
3. SPECIFICATION
Model no: ............................................................... LP100.V5
Supply: .............................................................. 230V ~ 50Hz
Power: .............................................................................70W
Gas type: ..................................................................Propane
Inlet pressure: ..............................................................0.7bar
Appliance category: ..........................................................IP3
Nominal heat output: ..................................................... 30kW
Gas consumption: ................................................... 2.18kg/hr
Electrical protection: ....................................................... IPX4
Airflow: ........................................................................650³/hr
Weight: .......................................................................... 6.3kg
4. OPERATION
4.1.
Refer to instructions in Safety section 1 above.
4.2.
Safety clearance see fig.2.
4.3.
Connect gas supply hose to pressure regulator and
connect regulator to a suitable LPG cylinder
(left hand threaded nut).
4.3.1.
Open the gas cylinder tap and check supply hose and
fittings for gas leaks. Use an approved leak detector or
soapy water.
NEVER USE NAKED FLAMES
4.4.
Connect to mains power.
4.5.
IGNITION
4.5.1.
Turn the power switch to position "I" and check the fan
starts running correctly.
4.5.2.
Push the gas valve button and repeatedly push the
piezoelectric lighter until the flame lights up see fig.3.
CAUTION If ignition is difficult or irregular before
repeating the ignition operations make sure that
the fan is not locked and that the air inlet and outlet
unobstructed.
4.6.
SWITCH OFF
4.6.1.
To stop the heater shut off the gas cylinder tap.
4.6.2.
Let the fan run until the flame shuts down and then turn the fan switch to position "O".
4.7.
ASPHYXIATION HAZARD
DO NOT use in domestic situations.
8
DO NOT use in unventilated areas. The flow of combustion and ventilation air must not be obstructed. Proper ventilation air must be
8
provided to support the combustion.
WARNING! If gas is smelt immediately switch off appliance at the gas bottle. Check the appliance for leaks using an approved leak
‰
detector, if the leak can not be found switch off gas supply and seek professional help. Be aware that in the event of a gas leak ensure
that the area is fully ventilated and any form of ignition should be avoided.
© Jack Sealey Limited
fig.1
fig.2
fig.3
Original Language Version
LP100.V5 | Issue:3(5) 05/03/19
Advertisement
