Page 3
65130 F286 65130 F285 Service set 6003 9095 00 for Ecco 40S, -401S, -402S Consists of parts with ref. Nos. 2, 3 (Qty 1), 7, 10, 11, 19, 20, 22, 23, 25, 27, 29 and 31. Part numbers in bold type designate consumption parts.
Nozzle sets Consists of air cap, paint nozzle of stainless steel and paint needle of nylon. Pressure feed Suction and Gravity feed Paint nozzle Paint needle Air cap Nozzle set Paint nozzle Paint needle Air cap Nozzle set Orifice diam. Orifice diam.
Operator’s Instructions Use Ecco genuine parts and accessories only for best function and safety. Before starting, read through all instructions carefully. Principal data Type Max. working Paint cup WARNING pressure volume Ecco The high velocity flow of air and liquids through hoses and nozzles may develop static electricity.
Page 6
Paint spraying Disassembly-Reassembly (see Fig. page 1) (see also Fig. 2) CAUTION VARNING Inhalation of paint, paint dust and solvent is not healthy. Make sure an approved spraybooth is used. The operator must use Before any intervention on the spray gun, shot off and relieved the compressed air supply and paint pressure to the gun.
Page 7
G 3/8 0.8-2 bar G 1/4 2-6 bar Fig. 1 65130 F225 Ecco 40S 2. Packing set 3. Packing screws 4. Fan with control 12. Paint needle 14. Back head 15. Spring 16. Wheel (Paint flow adjusting) 17. Trigger 21. Air valve 28.
Troubleshooting Introduction Types of problems Always commence troubleshooting by checking the general condition Collection of information which makes it possible to identify the error of the spray gun. This can most easily be determined by test spraying, symptoms applicable to the spray gun in the event of malfunctioning which provides an opportunity for checking the spray pattern and ca- is a matter of vital importance.