Advertisement
1
Install concealed ceiling system grid. Assemble the grid so there is a continuous
6-15/16" opening where luminaires will be installed. The installation area must
have at least 10" of overhead space from ceiling line.
Note: Do not hang ceiling drywall before luminaires are installed. Luminaires
must be mounted prior to installation of ceiling drywall to allow top access.
Wall Stud
5/8" Drywall
2
Hang or cut drywall along installation area so it is 1/16" above ceiling line.
Note: Drywallers must hang drywall to the specifications. Only cut if necessary.
Top of drywall
3
Mark locations along Wall Trim extrusion where it will be mounted to wall studs,
then drill holes as needed and mount to wall studs.
Note: Mount Wall Trim extrusion using at least 1 screw per 2', rounded up.
Mount Wall Trim
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Projected Location of
Hard Ceiling 5/8" Drywall
Ceiling Line
6-15/16"
Projected Location of
Hard Ceiling 5/8" Drywall
1/16"
Ceiling Line
Ceiling Line
ALS500T-RMW-MI
4
Determine number of Aircraft Cable Assemblies required.
Note: Refer to the diagrams on page 11 as a guide.
5
If applicable, assemble Aircraft Cable Assemblies. Use provided hardware to
secure Alignment Blocks and Cable Gripper to Flat Bracket.
Aircraft Cable
Screw
Cable Gripper
Hex Nut
Alignment Block
6
Determine locations where Aircraft Cables will be mounted overhead. Secure to a
sturdy surface, such as studs, using hardware (by others) that is rated for the
weight of the luminaire. Ensure each luminaire is appropriately balanced.
Note: Do not hang luminaire from weak material such as drywall or plywood.
7
Secure Aircraft Cable Assemblies to mounting surface. The top of the assembly
should rest approximately 5" above ceiling line. Adjust position of assembly along
aircraft cable using cable gripper. Do not trim excess cable at this time.
Mounting Surface
Cable Gripper
INSTALLATION INSTRUCTIONS
Mounting (Aircraft Cable Assembly) 1 of 3
Flat Bracket
Aircraft Cable
Excess cable
~ 5"
Ceiling Line
1 / 29 / 2021 / Rev 2
Page 7 of 16
Advertisement
