Advertisement
Quick Links
VANTAGE WIRELESS CHARGER VAN-W4F-5W/LI
MOUNTING INSTRUCTION "CONCEALED FURNITURE"
VAN-W4F-5W/LI+VAN-USB-C-W4F-5W01/LI+VAN-050250PS-A
Recommended top panel thickness
Mounting hole for Wireless charger
VAN-W4F-5W/LI 64mm diameter
Cable hole 25mm diameter
Please twist this knob
in CCW direction till
you feel resistance
Wireless charger
VAN-W4F-5W/LI
Air jack connector should be
disconnected before mounting
Round cable diameter 3.6mm
500mm
Step 1
PAGE-1
Vantage DC power supply
VAN-050250PS-A
USB HUB TYPE A/LI
1000mm
Advertisement
Related Manuals for Vantage Hearth VAN-W4F-5W/LI
Summary of Contents for Vantage Hearth VAN-W4F-5W/LI
- Page 1 PAGE-1 VANTAGE WIRELESS CHARGER VAN-W4F-5W/LI MOUNTING INSTRUCTION "CONCEALED FURNITURE" VAN-W4F-5W/LI+VAN-USB-C-W4F-5W01/LI+VAN-050250PS-A Recommended top panel thickness Mounting hole for Wireless charger VAN-W4F-5W/LI 64mm diameter Cable hole 25mm diameter Please twist this knob in CCW direction till you feel resistance Vantage DC power supply...
- Page 2 PAGE-2 VANTAGE WIRELESS CHARGER VAN-W4F-5W/LI Install VAN-W4F-5W/LI wireless charger into prepared hole (diameter 64mm) Cable hole 25mm diameter Step 2...
- Page 3 PAGE-3 VANTAGE WIRELESS CHARGER VAN-W4F-5W/LI If wireless charger device fits properly to the hole and you feel that device can not be pushed deeper pease twist this part in CW direction to lock Connect air jack connector after mounting in furniture...
- Page 4 PAGE-4 VANTAGE WIRELESS CHARGER VAN-W4F-5W/L Locker should look like picture shown when in the closed postion Step 4...
- Page 5 -One blink at power on -Constant blinking when Wireless charger is charging phone -The blue light disappears when phone is charged fully -Constant blinking-error Mounted properly Vantage wireless charger VAN-W4F-5W/LI Blue indicator Screw in the USB HUB using a Philips screwdriver...
- Page 6 PAGE-6 VANTAGE WIRELESS CHARGER VAN-W4F-5W/L This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.