Filling The Rinse Aid Reservoir - ETNA VW549ZIL Instructions For Use Manual

USING YOUR DISHWASHER

Filling the rinse aid reservoir

1. To open the dispenser, turn the cap to the "open" (left) arrow and lift it out
2. Carefully pour in the rinse-aid into its dispenser, whilst avoiding it to overflow.
Note: Clean up any spilled rinse aid with an absorbent cloth to avoid excessive foaming
during the next wash.
3. Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right)
arrow.
Adjusting the rinse aid reservoir
Dial to adjust
EN 14
Rinse-Aid indicator
The rinse aid reservoir has 6 settings. Both the recommended setting
and the factory setting is "4". If the dishes are not drying properly or are
spotted, adjust the dial to the next higher number until your dishes are
spot-free. Reduce it if there are sticky whitish stains on your dishes or a
bluish film on glassware or knife blades.