Keyboard - Lenovo ThinkPad P17 Gen 1 User Manual

6. Install a new M.2 solid-state drive:
a. Open the Mylar film
b. Align the contact edge of the new M.2 solid-state drive with the key in the slot
insert the drive into the slot at an angle of about 20 degrees and pivot the M.2 solid-state drive
downward 3 .
c. Install the screw to secure the M.2 solid-state drive
d. Cover the M.2 solid-state drive with the Mylar film.
7. Reinstall the bottom door.
8. Turn over the computer. Connect the ac power adapter and all disconnected cables to the computer.

Keyboard

Prerequisite
Before you start, read Generic Safety and Compliance Notices and print the following instructions.
Replacement procedure
Note: You might be instructed to slide the keyboard frame forward or backward in some of the following
steps. In this case, ensure that you do not press or hold the keys while sliding the keyboard frame.
Otherwise, the keyboard frame cannot be moved.
1. Disable the built-in battery. See "Disable the built-in battery" on page 23.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Remove the bottom door. See "Bottom door" on page 24.
1 .
4 .
Chapter 6
2 . Then, carefully
. 27
CRU replacement