Page 2
Used to switch RAID modes. ⑥ After switching the array mode, you need to press the reset button Rotary Switch to make the newly set array mode take effect. ⑦ Reset Reset the device to match its current hardware settings Model:D2-310...
Page 3
Lock the tray by pressing the handle after to insert the hard drive fully. the hard drive has been fully inserted into the device. If the hard drive tray locks without fully inserting it into the device, taking out fails or read/write is unstable. Model:D2-310...
Page 4
Step 2: Press and hold the RESET button for 5 seconds to let the newly-selected RAID mode take effect. Step 3: Return the rotary switch’s pointer to the desired RAID mode. Step 4: As before, press and hold the RESET button for 5 seconds to let the newly-selected RAID mode take effect. Model:D2-310...
Page 5
GPT partition, then the maximum partition capacity will be restricted at 2TB); 4. Once the disk initialisation process is finished, right-click the unallocated disk and select “New Simple Volume” from the drop-down menu; 5. Once you’ve created a new volume, the RAID initialisation process is complete. Model:D2-310...
Page 7
5. Once the “Erase” process is finished, RAID initialisation is complete. Warning! Changing your device’s RAID mode could lead to hard drive formatting, which would delete all data from the hard drives. Therefore, please back up your hard drive data before switching RAID mode. Model:D2-310...
Page 8
3. The data recovery process can last anywhere from several hours to tens of hours. The length of time taken depends on the hard drive capacity; 4. Both the device and your computer must be powered on for the duration of the data recovery process, otherwise, data recovery will be interrupted. Model:D2-310...
Need help?
Do you have a question about the D2-310 and is the answer not in the manual?
Questions and answers