Durapac DHS-05 Instruction Manual
  1. Manuals
  2. Brands
  3. Durapac Manuals
  4. Spreader
  5. DHS-05
  6. Instruction manual

Durapac DHS-05 Instruction Manual

Hydraulic remote spreaders
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Instruction Manual
Hydraulic Remote Spreaders
Models – DHS-05 & DHS-1
Maximum Operating Pressure – 700 bar
ABSOLUTE EQUIPMENT PTY LTD – 2/186 Granite Street, GEEBUNG QLD 4034 – Australia
sales@absoluteequipment.com.au
– Phone:
+61 7 3865 4006
– Fax:
+61 7 3102 6288

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DHS-05 and is the answer not in the manual?

Questions and answers

Related Manuals for Durapac DHS-05

Summary of Contents for Durapac DHS-05

  • Page 1 Instruction Manual Hydraulic Remote Spreaders Models – DHS-05 & DHS-1 Maximum Operating Pressure – 700 bar ABSOLUTE EQUIPMENT PTY LTD – 2/186 Granite Street, GEEBUNG QLD 4034 – Australia sales@absoluteequipment.com.au – Phone: +61 7 3865 4006 – Fax: +61 7 3102 6288...

  • Page 2: Product Information

    The user must ultimately make the decision regarding suitability of the product for any given task and assume the responsibility of safety for all in the work area. Contact a Durapac representative if you are unsure of your spreader’s suitability for a particular application.
  • Page 3  Hydraulic equipment must only be serviced by a qualified hydraulic technician. For repair service, contact the Durapac authorised service centre in your area. To protect your warranty, use only high quality hydraulic oil CAUTION: ...

  • Page 4: Installation

    4.1 Familiarise yourself with the specifications and illustrations in this owner’s manual. Know your spreader, its limitations and how it operates before attempting to use. Refer to the specification chart below or if in doubt, contact a Durapac representative. Model...

  • Page 5: Operation

    For complete operating instructions refer to the instruction sheet included with each pump. The DHS-05 and DHS-1 spreaders have a spring return cylinder and the speed of retraction is affected by the length of the hose and other restrictions in the line. Most 700 bar hand or power pumps for use with single acting tools are compatible with the DHS-05 and DHS-1 spreaders.

  • Page 6: Maintenance

    Durapac authorised service centre  Damage to hydraulic hoses may not be detected during visual inspections. For this reason, Durapac recommends that hydraulic hoses be replaced on a regular basis  Tighten connections as needed. Use non-hardening pipe thread compound when servicing connections Dirt, sand, etc.

  • Page 7: Troubleshooting

    Replace both male and female couplers  Improper valve position Close release valve or shift to new position  Low or no hydraulic fluid in Fill and bleed the system pump reservoir DHS-05 & DHS-1 Spreader - V1.4 www.durapac.com Page 7 of 10...
  • Page 8 Low fluid level in pump Fill and bleed the system reservoir  Leaking cylinder seals Replace worn seals  Check for excessive contamination or wear  Replace contaminated fluid as necessary DHS-05 & DHS-1 Spreader - V1.4 www.durapac.com Page 8 of 10...

  • Page 9: Parts Breakdown And List

    11 Coupler ZAL1472 Seal kit ZAL1639 Items marked with a * are contained within a standard seal kit. Serial, model and part numbers need to be quoted when ordering parts. DHS-05 & DHS-1 Spreader - V1.4 www.durapac.com Page 9 of 10...
  • Page 10 Note – Not all components of this Hydraulic Spreader are 13 Coupler, spreader replacement items, but are illustrated as a convenient 14 Coupler cap reference of location and position in the assembly sequence. 15 Dust cover DHS-05 & DHS-1 Spreader - V1.4 www.durapac.com Page 10 of 10...

This manual is also suitable for:

Dhs-1

Table of Contents