PowerTec 71468 Instruction Sheet

INSTRUCTION SHEET
71468 Featherboard 1 pack
71393 Featherboards 2 pack
QUESTION...
1•847•780•6120
WARNING
For your own safety, read all of the rules and precautions
before operating tool.
WARNING
Always follow proper operating procedures as defined
in this manual even if you are familiar with use of these
featherboards or any tool used with these featherboards.
Remember that being careless for even a fraction of a
second can result in severe personal injury.
You must be familiar with the use of any tool or accessory
used with these featherboards. The supplier cannot
be held responsible for any accident, injury or damage
incurred while using this featherboard with any tool.
WARNING
Some dust created by operation of power tool contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. To
reduce your exposure to these chemicals, work in a well
ventilated area and work with approved safety equipment.
Always wear OSHA/NIOSH approved, properly fitting face
mask or respirator when using such tools.
CAUTION
Do not modify or use the featherboards for any application
other than that for which it was designed.
FEATHERBOARD SAFETY RULES
• Disconnect the plug from the power source of the power
tool before changing accessories, Such preventive
safety measures reduce the risk of starting the power
tool accidentally.
• Always keep your hands away from the cutting area.
• Assemble the featherboard(s) at least 1" (2.5 cm) from
the saw blade to prevent kickback.
• Do not use the featherboard as a push block.
CAUTION
Think safety! Safety is a combination of operator common
sense and alertness at all times when tool is being used.
WARNING
Do not use the featherboards until they are completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with these featherboards.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
A Featherboard
B Locking knobs
C Washers 5/16"
D Screws, 5/16"-18 x 2" long
E Screws, 5/16"-18 x 3" long
F T-bolts 5/16"-18 x 2-1/2" long
G Spacers
* NOTE: These spacers allow
two 71468 Featherboard
1 packs to be used in the
double stack application.
H Miter bar slot brackets
Figure 1
A
A
71468 71393
QTY QTY
1 2
2 4
2 4
2 4
0 2
2 4
2* 4
2 4
H
G
C
D
E
F
B