Summary of Contents for Waspper WP15
- Page 1 Instruction Manual WP15 Engine driven Translation of the original operation manual. * The picture of the device is illustrative and doesn’t necessarily correspond to the actual display of the supplied device...
-
Page 2: Table Of Contents
– for pumping clean water from wells, streams and tanks; – with accessories and spare parts approved by Waspper s.r.o. - In an environment where the device will not be exposed to direct splashing of contaminated water with solid particles. -
Page 3: Scope Of Delivery
95 into the tank. The standard supplied terminals have the following dimensions: WP15- 1,5”/38mm Putting into Operation WARNING Don’t start the pump without pre-filling the pump with water. Running a dry pump will damage the sealing element on the shaft. -
Page 4: Engine
pipe. Subsequently, put Cap 3 back into the pump turning it to the right (clockwise) and tighten it by hand. Check the tightness of Drain Cap 4. Excessive tightening with pliers may result in damaging the cap. Immerse the suction hose suction strainer into the water source needing to be pumped. -
Page 5: Engine Maintenance
exhaust does not remain pointed at persons standing in the vicinity or any opening in nearby structures (garages, galleries, cellars, etc.). When in operation, the engine produces waste heat, resulting in heat-up of various engine components (exhaust, engine cylinder), which may cause serious burns. These components may cause fire, when in contact with flammable materials. - Page 6 During operation, in rare cases, protective metal covers may become loose due to vibration. It’s necessary to tighten these components as the long-term effect of vibrations on the loosened cover causes damage to the mounting holes. If the exhaust, air filter or cooling fan protective cover is damaged, these parts have to be replaced by original parts as this is the only case where maximum safety can be guaranteed.
-
Page 7: Pump
Engine Oil Specification Engine oil is one of the main factors affecting engine performance and life. The minimum requirements to be met by the oil are: viscosity class of 10W30 or 10W40 with quality level of SF and higher (SG, SH, SJ). The use of 10W30 engine oil at temperatures higher than 27 °C can lead to increased oil consumption. -
Page 8: Troubleshooting
A list of approved service centres is available on our website: www.waspper.com The effort of Waspper s.r.o. is to continuously improve the technical characteristics and user comfort of its products. For this reason, the manufacturer reserves the right to change the design and controls of the device without prior notice to the final customer. -
Page 9: Declaration Of Conformity With Eu
EU Declaration of Conformity The company Waspper s.r.o. hereby declares that the water pumps defined below comply with the relevant EU directives on occupational health and safety of the device operators. Any alteration of the device without the prior consent from the manufacturer will render this declaration void. - Page 10 This registration enables the customer to avoid further procedures, as submitting of the purchase receipt or the warranty certificate. 1. The manufacturer - Waspper s.r.o. - is liable for inherent defects of the product purchased, if such defects become evident within the warranty period.
Need help?
Do you have a question about the WP15 and is the answer not in the manual?
Questions and answers