Amana Goodman RSKP0013 Installation Instructions Manual

PTAC Control Board Kit RSKP0013
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know
the product better than the customer. This includes all safety
precautions and related items.
Prior to actual installation, thoroughly familiarize yourself with this
Instruction Manual. Pay special attention to all safety warnings.
Often during installation or repair it is possible to place yourself
in a position which is more hazardous than when the unit is in
operation.
Remember, it is your responsibility to install the product safely
and to know it well enough to be able to instruct a customer in its
safe use.
Safety is a matter of common sense...a matter of thinking before
acting. Most dealers have a list of specific good safety practices...
follow them.
The precautions listed in this Installation Manual are intended as
supplemental to existing practices. However, if there is a direct
conflict between existing practices and the content of this manual,
the precautions listed here take precedence.
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
Only personnel that have been trained to install, adjust, service
or repair (hereinafter, "service") the equipment specified in this
manual should service the equipment. The manufacturer will not
be responsible for any injury or property damage arising from
improper service or service procedures. If you service this unit,
you assume responsibility for any injury or property damage
which may result. In addition, in jurisdictions that require one or
more licenses to service the equipment specified in this manual,
only licensed personnel should service the equipment.
Improper installation, adjustment, servicing or repair of the
equipment specified in this manual, or attempting to install,
adjust, service or repair the equipment specified in this manual
without proper training may result in product damage, property
damage, personal injury or death.
PROP 65 WARNING
FOR CALIFORNIA CONSUMERS
Cancer and Reproduc�ve Harm
www.P65Warnings.ca.gov
IO-904B
under license to Goodman Company, L.P., Houston, TX, USA. All rights reserved.
1/2020
Installation Instructions
WARNING
WARNING
-
19001 Kermier Rd., Waller, TX 77484
is a registered trademark of Maytag Corporation or its related companies and is used
© 2015 - 2016, 2020 Goodman Company, L.P.
DESCRIPTION
Control board installation procedures are described in detail in
these instructions. Read and follow these instructions carefully
before replacing the control board. Failure to do so may result
in control board damage. Pages 3 through 5 are procedures for
programming the control board and the diagnostic codes for the
control board.
Important note:
Damage to the control board can occur from failure to disconnect
power supply or failure to set the master switch (located on the
control board) to OFF before removing the low voltage terminal
strip cover from an installed control board. Damage to this board
by not following these instructions is considered misuse and not
covered under either the standard unit warranty or any extended
service contract.
Important note:
All warranty replaced boards must be returned to the parts source
from which they were purchased to insure proper warranty credit.
ELECTROSTATIC DISCHARGE (ESD)
PRECAUTIONS
Before removing the new control board from the static wrap, it
is very important to discharge any static electricity. This can be
accomplished in two methods. Servicer can wear a ground strap
or by touching the metal chassis before replacing the board.
EXISTING CONTROL BOARD REMOVAL
PROCEDURES
1. Disconnect electrical power to the unit.
2. Remove front cover.
3. Remove the two mounting screws, one on each side of
control board cover. Lift the cover up to gain access to
the ribbon connector. Unplug ribbon connector from
control board and remove cover completely. Remove the
screw on right side of the control panel.
0140M00517-A
www.amana-ptac.com