Leveling The Appliance - LG FDV708W Owner's Manual

• Please ensure that when the appliance is
installed, it is easily accessible for an engineer
in the event of a breakdown.
• With the appliance installed, adjust all four
feet using a spanner to ensure the appliance
is stable, and a clearance of approximately 20
mm is left between the top of the appliance and
the underside of any work-top.
Ventilation Requirement
• Alcove or under counter
− Ensure air flow of 3.17 m
appliance
• Closet
− Closet door must have 2 (louvered)
openings, each having a minimum area of
387 cm , located 8 cm from bottom and top
2
of door.
WARNING
• Avoid installing the appliance around a heat
source. The rear side of the appliance must
be well ventilated. Failure to follow these
instructions may result in problems.
• The appliance should not be installed next to a
refrigeration appliance.
• The appliance is not designed for maritime
use or for use in mobile installations such as
caravans, aircraft etc.
Electrical Connection
• Do not use an extension cord or double
adapter.
• Always unplug the appliance after use.
• Connect the appliance to an earthed socket in
accordance with current wiring regulations.
• The appliance must be positioned so that the
plug is easily accessible.
12
/min through the
3

Leveling the appliance

Checking the Level
Leveling the appliance prevents unnecessary
noise and vibration. Check whether the appliance
is perfectly level after installation.
• If the appliance rocks when pushing the top
plate of the appliance diagonally, adjust the feet
again.
Adjusting and Leveling the
appliance
When the appliance is not perfectly level, turn
the adjustable feet until the appliance no longer
wobbles.
• Turn the adjustable feet clockwise to raise
or turn the adjustable feet counterclockwise
to lower from front-to-back, side-to-side and
corner-to-corner.
Reversing the door
You can reverse the door for your convenience.
WARNING
• Do not reverse the door while the appliance is
stacked on a washing machine.
• Before removing the hinge screws, have an
assistant support the weight of the door. The
door could fall on the floor due to the weight of
the door.
• For safety reasons, two or more people need to
work together to reverse the door.
NOTE
• The appearance of the screws varies and the
screws must be inserted differently depending
on the position. Make sure the screw is
properly selected before tightening.
EN