Table of Contents
Advertisement
CAUTION: You will need to build the island unit before assembling the side burner. While it is possible for one
person to assemble this side burner, obtain assistance from another person when handling some of the larger,
heavier pieces.
Install Side Burner Lid Knob and Ignitor Battery
1
Open the Side Burner Lid.
Align the hole on the Side Burner Lid and the hole on the Side Burner Lid Knob. From the underside
of the Side Burner Lid, insert 1 Phillips Head Screw M4x8 and tighten securely.
Remove Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor Slot with positive pole facing you.
Position the Cap and Spring over the AA battery and tighten onto Control Panel.
Phillips Head Screw
M4x8
Qty. 1
Part # S112M04081
Lid Knob
Qty. 1
Part # P00215001B
Install NG Regulator and 12 Foot Hose (For BGTSBNG Model)
2-1
Install the NG Regulator onto the Manifold Extension Fitting and tighten securely.
Connect the Swivel Nut of the 12 foot Hose onto the NG Regulator.
12' Natural
Gas Hose
Assembly Instructions
Ignitor Slot
AA Battery
Ignitor Cap
Manifold
Vertical
Fitting
Swivel Nut
-
+
Spring
Island shown for illustrative purposes.
7
Advertisement
Table of Contents
