Table of Contents
Advertisement
■
Remote Engine Start
You can remotely start the engine using the two-way keyless access remote from
extended distances.
■
To start the engine
Press the
button, then press and hold
the
button.
Amber LED: Blinks when any button is pressed.
Continues to blink
during a vehicle
self check until the
engine starts.
Green LED: Comes on while
the engine is running.
The engine runs for up to 10 minutes without you starting the vehicle.
To extend the run time for another 10 minutes during the first run, press the
button, then press and hold the
u
The amber LED blinks, then the green LED comes back on if a 10-minute
extension request was transmitted successfully.
After pressing the (lock) button, wait for the green LED to blink. This indicates that
the all the doors and the tailgate are locked.
* Not available on all models
*
Go within the range,
and try again.
Red LED: Blinks when the
remote is out of the keyless
access system range.
button.
uuWhen DrivinguStarting the Engine
*
1Remote Engine Start
WARNING
3
Carbon monoxide gas is toxic and can
rapidly accumulate in closed or even partly
enclosed areas.
Breathing it can cause unconsciousness and
even kill you.
Never use the remote engine starter with
the vehicle parked in a garage or other
areas with limited ventilation.
The remote engine start may violate local laws.
Before using the remote engine start, check your
local laws.
If there are buildings and obstacles between your
vehicle and the remote, the range will be reduced.
This distance may vary by external electrical
interference.
The engine may not start by the remote engine start if:
•
You have disabled a remote engine start setting
using the multi-information display.
•
The power mode is not in VEHICLE OFF (LOCK).
•
The transmission is in a position other than
•
The hood is open, or any door or the tailgate is
unlocked.
•
You have already used the remote twice to start
the engine.
Continued
.
(
P
413
Advertisement
Chapters
Table of Contents
