Advertisement
1
REFRIGERATED PREP TABLES
Installation, Operation and Maintenance Instructions
Please read this manual completely prior to installing and operating this equipment.
This manual describes how to install, operate and maintain the product in order to
obtain the optimum in performance, efficiency and reliability.
7/20 171216
Advertisement
Table of Contents
Summary of Contents for Norlake SP27-8
- Page 1 REFRIGERATED PREP TABLES Installation, Operation and Maintenance Instructions Please read this manual completely prior to installing and operating this equipment. This manual describes how to install, operate and maintain the product in order to obtain the optimum in performance, efficiency and reliability. 7/20 171216...
-
Page 2: Table Of Contents
START-UP AND OPERATION CLEANING AND MAINTENANCE TROUBLE SHOOTING GUIDE WIRING DIAGRAMS SPECIFICATIONS STANDARD TOP PREP TABLES CAPACITY MODEL STORAGE (FT³) PANS (1/6TH) ELECTRICAL REFRIGERANT WEIGHT (lbs) SP27-8 115/60/1/3.5 R290 SP36-10 115/60/1/3.5 R290 SP48-12 12.5 115/60/1/3.5 R290 SP60-16 15.9 115/60/1/3.5 R290 SP72-18 19.2... -
Page 3: Receiving Inspection
RECEIVING INSPECTION Congratulations on your purchase of a quality built appliance. When properly installed and maintained this product will give many years of trouble free service. It was shipped using trusted carriers with a history of careful handling, good customer service and prompt delivery. -
Page 4: Safety Information
SAFETY INFORMATION This manual may contain notices that identify situations that could cause death, serious injury and /or damage to the appliance or property. Please make note of the following definitions; ! WARNING Indicates a hazardous situation which could result in death or serious injury. - Page 5 • Do not use the appliance should the power cord become damaged. The power cord should not be altered, jerked, pinched, bundled and/or used to hang objects from. Such actions could result in electrical shock or fire. To disconnect the unit from power, be sure to grasp and pull on the plug, not the cord.
-
Page 6: Set-Up And Installation
SET-UP AND INSTALLATION CAUTION This unit uses a flammable refrigerant. Use care when handling and operating to avoid damaging the refrigerant tubing or increasing the risk of a leak. ! WARNING This appliance must be installed in accordance with all applicable national, state and local regulations. - Page 7 Once the Casters or Legs installed the unit can be returned to its upright position. Be sure to work in pairs when returning the unit to the upright position. NOTICE Do not operate the unit for 1 hour after returning the unit to its upright position to allow the oil to settle in the Compressor.
-
Page 8: Reversing The Door Swing (27" Models)
Locating the Appliance The unit needs to have Casters or Legs installed to operate properly. IMPORTANT • Confirm that the floor in the installation location is strong enough to support the unit. • Confirm that the ambient temperatures are within the tolerances allowed. •... - Page 9 8. The spring (left) is already in the pocket on the top left corner of the door. Important - The straight end of the spring will need to be inserted into a small hole in the bottom of the pocket so when it is rotated it has tension. 9.
-
Page 10: Start-Up And Operation
START-UP AND OPERATION After meeting the set-up and installation requirements the unit is ready to start-up. Once the power cord is connected to a live outlet the unit will start running. Allow the unit to run for two (2) hours prior to loading it with product. Temperature Adjustment The Temperature Control is located on the inside back wall of the unit and comes pre- set to the mid-point position which will give internal temperatures of approximately... -
Page 11: Cleaning And Maintenance
CLEANING AND MAINTENANCE All service should be performed by factory authorized personnel. All component parts shall be replaced with like components to minimize the risk of possible ignition due to incorrect parts or improper service. ! Warning Disconnect the unit from the power supply prior to conducting any maintenance, cleaning or servicing the appliance. -
Page 12: Trouble Shooting Guide
Disconnect the power to the unit prior to cleaning the Condenser Coil. Periodic cleaning is necessary to help the refrigeration system operate at peak efficiency and to maintain warranty. Steps. 1. Disconnect the unit from power 2. Remove the rear grill 3. -
Page 13: Wiring Diagrams
Wiring Diagram 7/20 171216...