Lenovo ThinkVision T22i-20 User Manual page 11

7. Connect one end of the USB cable to the USB downstream terminal of the monitor, and connect the
8. Plug the monitor power cord and the computer cord into grounded electrical outlets.
9. Assembled cables with Line Cleaner as shown below.
1-6 T22i-20 Flat Panel Monitor User's Guide
other end of the USB cable to an appropriate USB port on your device.
Note: The USB Battery Charging Specification 1.2 output 5Vdc/1.5A(typical), 2A (max) and the
other three standard USB Output 5Vdc/900mA.The USB downstream port does not provide power
while the monitor is switched off.
Note: A certified power supply cord has to be used with this equipment. The relevant national
installation and/or equipment regulations shall be considered. A certified power supply cord not
lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227 (designation
H05VV-F 3G 0.75mm² or H05VVH2-F2 3G 0.75mm²) shall be used. Alternative a flexible cord be
of synthetic rubber according to IEC 60245 (designation H05RR-F 3G 0.75mm²) shall be used.
If there are any * tag, you can consult the comments on page 1-1.