Universal Furniture 988-920 Instruction Sheet

988/989-920/921/963/966/964
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use every day, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list is attached to the furniture and kept tightened at all
times.
PARTS LIST:
# Description
A Console
C Left Pier
E Shelf
G Hardware Pack
Note: The tipping restraint kits are located on the back of piers (B & C). Always use tipping restraint kits for
safety.
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Remove the upper side strips from console (A).
Step 3: Position left and right piers (C & B) next to console (A) as shown. Place the bridge (D) on
the piers (C & B).
Step 4: Insert L clips (1) in desired position then carefully rest the shelf (E) on the clips and secure
with screws (2) a Phillips head screwdriver (not provided). Place the storage towers (F) on
console (A) top as shown.
Note: When the 988/989-964 54"wide TV console is used with piers, the shelf (E) can not be
installed.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
1 pc B
1 pc D
1 pc F
1 bag
: (Please follow the sketches below.)
Wall Unit
Description
Right Pier
Bridge
Storage Tower
Qty.
1 pc
1 pc
2 pcs