Summary of Contents for DAVIS Interface Cable Adapter Module
Page 1
The Interface Cable Adapter Module (ICAM) has two basic uses. First, it enables you to run shielded cable between the industrial sensor interface module (SIM) and the weather station console. The ICAM provides the means of transition from shielded cable to the standard cable that plugs into the console.
Page 2
OMPONENTS The ICAM includes the following components. Please make sure you have all listed components before continuing. Interface Cable Adapter Module 16.5-foot (5 m) Ground Wire (12 AWG) Three #6 x 1” (25 mm long) Self-Threading Screws Two Cable Ties...
Page 3
1. Before installing, consult your system installation manual for instructions on labeling cables. 2. Remove the cover from the ICAM by pushing down on the tabs at the top until you can remove the tabs from the slots. Mounting the Interface Cable Adapter Module ABLE DAPTER EMOVING THE...
Page 4
4. If you plan to place the ICAM on a horizontal surface, attach an adhesive pad to each of the four raised circles on the underside of the base. Otherwise, skip this step. Page 4 TTACHING THE ASE TO THE OUNTING TTACHING DHESIVE URFACE Interface Cable Adapter Module...
Page 5
Cut off any excess drain wire. If running standard 8-conductor cable from the SIM to the ICAM, you may connect to either modular connector C2 or terminal block connector C2 (continued on next page). Mounting the Interface Cable Adapter Module Page 5...
Page 6
When you release the lever, the wire(s) will be held in place. Page 6 Interface Cable Adapter Module...
Page 7
Even if you have only one cable, secure it to provide strain relief. When tightening the cable tie, make sure the cable is on top of the lug. Mounting the Interface Cable Adapter Module ICAM ROUNDING THE...