All information in this manual is based upon the latest product information available at the time of publication. At Kohler, we constantly strive to improve the quality of our products. We reserve the right to make changes in product characteristics, packaging or availability at any time without notice.
Do not relocate the blower motor, or make other modifications to the system in the absence of kit instructions, as this could adversely affect the performance and safe operation of the bath with airjets. Kohler shall not be liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized modification.
Unpack bath shell and skirt and check for any transit damage prior to installation. ¨ Position the bath shell in the desired location in the bathroom. ¨ Check that the plumbing can be connected to the bath when in the desired location. ¨ 1204153-X2-A Kohler Co.
Page 5
2 screws in the diagonal. Adjust the nut on the feet, making the nut lower 2-3 mm than the clip. ¨ Readjust the feet height, making the feet lower 5 mm than the apron. ¨ Kohler Co. 1204153-X2-A...
Page 6
2mm longer than the bracket in every side). Press down the bracket button and adjust the pillow to a proper angle, recommend for three adjust angles. ¨ In case the bracket button is loose, please tighten it. Pillow Pillow Bracket Button 1204153-X2-A Kohler Co.
Page 7
Do not remove the plug grounding pins. Do not use grounding adapters. NOTE: Electronic parameter label located on the controller. This label also identifies the electrical rating. Your Kohler bath with airjets is equipped with a cord and plug. The blower motor has been wired at the ¨...
NOTE: Please read these steps carefully before you operate your bath with airjets. Troubleshoot any problems using the “Troubleshooting” section. NOTE: Please do not use the bath in case of outage. In this case, the electronic drain automatically opens and the bath can not be filled with water. 1204153-X2-A Kohler Co.
After running for 20 minutes, BubbleMassage will automatically turn off. Press electronic drain on/off button to open the drain. When water level drops below airjet holes, auto cleaning will activate for 2 minutes. Water Temperature Manual Purge Pump On/Off Decreases/Increases Flow Electronic Drain On/Off Kohler Co. 1204153-X2-A...
White-Blue 3. Light Change to Stand by Situation Water Temperature Pink 50% Blue White (Light depend on water temperature) 4. Blower Open Drain Close BBM Open Adjust the Strength of BBM Water Temperature (Blue-Orange-Red) (Pink) (Blue) (White-Blue) 1204153-X2-A Kohler Co.
Page 11
Bath Operation (Cont.) 5. Drain Open Green 50% Blue White 6. Overflow Alarm Green (Flash) 50% Blue White 7. System Clean 50% Blue White Orange Kohler Co. 1204153-X2-A...
Page 12
H. Compelling Drain Function If the overflow level sensor does not work, you can use the compelling drain function to prevent water ¨ overflow to your bathroom. Please refer to the automatic drain water level in the Roughing-in. 1204153-X2-A Kohler Co.
Troubleshooting This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified eletrician should correct all electrical problems. For warranty service, contact your dealer or call center. Symptoms Probable Causes Recorrection Action 1. Bath with airjets does not A.
B. Lower the water level in the bath. level. C. Overflow level is not correct. C. Contact customer service personnel of Kohler to readjust the water level. 12. Water temperature A. User keypad cable trips. A. Check wire connections, or replace cannot be shown.
Need help?
Do you have a question about the K-98155X and is the answer not in the manual?
Questions and answers