Advertisement
3.
PrEPArinG driLL For uSE
3.1.
Air Supply
WArninG! Ensure the air supply is clean and does not exceed 90psi while operating
p
the drill . Too high an air pressure and unclean air will shorten the product life due to
excessive wear, and may be dangerous causing damage and/or personal injury .
3 .1 .1 . Ensure drill air valve (or trigger) is in the "off" position before connecting to the air supply .
3 .1 .2 . You will require an air pressure of 90psi, and an air flow according to specification .
3 .1 .3 . Drain the air tank daily . Water in the air line will damage the drill .
3 .1 .4 . Clean air inlet filter weekly . Recommended hook-up procedure is shown in fig 1 .
3 .1 .5 . Line pressure should be increased to compensate for unusually long air hoses (over 8
metres) . The minimum hose diameter should be 1/4" internal diameter and fittings must have
compatible dimensions .
3 .1 .6 . Keep hose away from heat, oil and sharp edges . Check hose for wear, and make certain
that all connections are secure .
3.2.
couplings.
Vibration may cause failure if a quick change coupling is connected directly to the drill . To
overcome this, connect a leader hose to the drill (Sealey ref: AH2R or AH2R/38) . A quick
change coupling may then be used to connect the leader hose to the air line recoil hose .
See fig 1 & fig 2 .
fig 1
4.
oPErAtinG inStructionS
WArninG! Ensure you read, understand and apply Section 1 safety instructions.
p
4.1.
Turn front of chuck head to open, insert drill bit and turn chuck head to lock drill bit .
4.2.
Connect the drill to the air hose as described in Section 3 .
4.3.
Push the safety lock forward and depress the throttle lever to operate the drill accordingly .
4.4.
The flow of air may be regulated by turning the large headed screw on the drill body
opposite the trigger mechanism .
Original Language Version
fig 2
SA622 .V2
Issue: 1 - 08/09/11
Advertisement
