Advertisement
Materials needed:
Battery module or USB to micro USB cord (as a power
source)
Any NeuLog sensor
NeuLog WiFi module
Any device with wireless capabilities.
Control and view modes:
When multiple users are connected to the WiFi module‟s network;
one user at a time can enter "control mode" the others users will be
defaulted to "view mode".
Control mode
Entering control mode allows that user to manipulate the
experimental parameters and begin data collection using the web
application – this prevents multiple users from all trying to change
the experiment at once.
To leave control mode, simply click the "Tools" icon and then the
"Relaese master" buton.
View mode
In view mode; users have almost full access to the web application –
only lacking the ability to manipulate data and start/stop experiments.
Users in view mode have the full ability to view data in real time.
NEULOG WIFI COMMUNICATION MODULE GUIDE
Important:
In the event that anyone used the WiFi module as the controller and
forgot to disconnect from it, the WiFi module will not allow any other
user to connect to the WiFi module as a controller until it is restarted.
In order to allow another controller to access the WiFi module, press
and hold the push button located on the front panel of the WiFi
module for 3 seconds until all 3 lights turn on – this will refresh the
module resetting it back to having no users in "Control Mode".
Access point mode use:
Access point mode is the default operating mode for the the NeuLog
WiFi module – it transmits it‟s own closed wireless network which
allows up to 5 devices to connect to it at a time. No prior wireless
networks are required, making this option both very portable and
unique. Because the network is closed; you will not be able to
browse the internet, if you wish to browse the internet while using the
WiFi module please locate the "Client Mode" procedural guide in this
manual. Connect up to 5 NeuLog sensors directly to the left side of
the WiFi-202 module (no wires required).
1.
Connect either a BAT-200 or a USB to micro USB cable
connected to a power source, to the WiFi-202 module to supply
power.
2.
The WiFi-202 indicator lights will flash; take no action until the
LED indicator turns only blue.
3.
Take your tablet or smart phone and go to the Wi-Fi settings and
select the NeuLog network which matches the WiFi module ID
Advertisement
