Advertisement
5. MAINTENANCE
WARNING! Disconnect wrench from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1.
If the air system does not have an oiler, lubricate the air wrench daily with a few drops of
Sealey air tool oil dripped into the air inlet to prolong its life.
5.2.
Clean the wrench after use. DO NOT use worn or damaged sockets.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or
type of hose connectors. To remedy check the air supply and follow instructions in
chapter 3.
b) Grit or gum deposits in the wrench may also reduce performance. If your model has an air
strainer (located in the area of the air inlet), remove the strainer and clean it. Flush the
wrench out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin.
Allow to dry before use.
5.4.
For a full service contact your local Sealey service agent.
5.5.
When not in use, disconnect from air supply, clean wrench and store in a safe, dry,
childproof location.
5.6.
Periodically lubricate ratchet yoke drive shaft using grease nipple on side of the ratchet head.
This will reduce friction and increase the power and longevity of the tool.
The SA609 & SA610 Air Ratchet Wrenches, when operated in accordance with these instructions and tested in
accordance with EN 28662-2: 1994 result in the following vibration emissions declared in accordance with
BS EN12096: 1996.
Measured vibration emission value: ................................ (SA609) 2.5m/s² (SA610) 2.5m/s².
Uncertainty: ..................................................................... (SA609) 1m/s² (SA610) 1m/s²
These values are suitable for comparison with emission levels of other tools that have been subject to
the same test.
These tools may cause hand-arm vibration syndrome if their use is inadequately managed.
Recommended Measures to reduce risk of hand-arm vibration syndrome: These items represent a low
Hand Arm Vibration risk to users. The calculated minimum usage period exceeds 8 hours. We recommend
appropriate safety equipment is utilised and regular breaks for the operator are employed to reduce any
residual risk of fatigue or repetitive strain injury.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Risk of Hand Arm Vibration Injury.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
Web
01284 703534
sales@sealey.co.uk
email
SA609, SA610
Issue: 2 - 10/11/09
Advertisement
