Electrolux EWF 1284EMW User Manual page 23

Problem
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The cycle is shorter
than the time displayed.
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an op‐
tion.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
Possible solution
Make sure that the drain filter is not clogged. Clean the fil‐
ter, if necessary. Refer to "Care and cleaning".
Adjust manually the items in the tub and start the spin
phase again. This problem may be caused by balance
problems.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure the levelling of the appliance is correct. Refer to
"Installation".
Make sure that the packaging and/or the transit bolts are
removed. Refer to "Installation".
Add more laundry in the drum. The load may be too small.
The appliance calculates a new time according to the laun‐
dry load. See the "Consumption Values" chapter.
An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
Increase the detergent quantity or use a different deter‐
gent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
ENGLISH 23