Advertisement
2. INTRODUCTION & SPECIFICATION
Portable powder coated metal construction with two ceramic heating ele-
ments provide instant heat when required. Polished reflectors maximise the
heat emission. Output is controlled by rocker switches fitted to the frame.
Carry handle allows for safe movement whilst in use. Sturdy legs provide a
secure base. supplied with 2m cable fitted with 32Amp/110V
rated plug.
min. Power:
Max. Power:
Input supply:
Heater Dimns.(W x D x H):
Weight:
Heater Identification Fig.1
1) Heater Element
2) safety Guard
3) Heater Body
4) Handle
3.
CERAMIC ELEMENTS
DO NOT touch an element just after switching 'off' power supply. Allow to cool.
Ensure that the heating elements are:
• free of fractures and cracks and are of good general condition.
• Maximum of 1400W each.
WARNING! There are no user serviceable components inside this heater, if an element requires replacing please return to an authorised
Sealey dealer.
4. OPERATION
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before
using the heater.
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary
shocks or vibration and is not moved when it is on or until cooled down.
4.1
Ensure the heater is at least 2m from any object.
4.2
Plug in the heater and switch it on.
4.3
The heater has the following settings: See (Fig.2).
Position 0:0
Off position.
Position i:0
Upper element only.
Position 0:I
lower element only.
Position I:I
Both elements.
4.4
When the heater is no longer required, switch off and unplug the unit.
iMPorTAnT: DUrinG rELocATion, THE HEATEr sHoULD rEMAin sWiTcHED off AnD
DisconnEcTED froM THE PoWEr sUPPLY.
In the event of the heater being knocked over, a safety cut-out switch, which activates at an angle of 35º ±10º,
will disable the heater.
Follow these steps to re-start the heater.
a)
switch 'off' the heater at the on/off switches. As (fig.2).
b)
Disconnect the power cord from the power supply.
c)
Return the heater to a standing position.
d)
If no damage has occurred to elements, replace safety guard if applicable, re-connect power cord to the
power supply and switch the heater back on.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a
suitably qualified person.
© Jack Sealey limited 2013
1400W
2800W
110V 32A
360 x 370 x 555mm
6.5kg
5) Power on Neon
6) Power on/off
7) Stand
1
2
3
Original Language Version
4
5
Fig.1
7
6
Fig.2
On
Off
On
Off
cH28110V
issue: 1 - 05/03/13
Advertisement
