Summary of Contents for Kimo QM-6001
- Page 1 INSTRUCTION MANUAL 20-Volt Lithium-ion Cordless Leaf Blower 2-in-1 Sweeper/Vacuum Kimo-support@kimotools.com Catalog Number: QM-6001 IMPORTANT: Read Before Using...
-
Page 2: Specifications
EPTA-Procedure 01/2014, are shown in the table. WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may cause injury and/or fire. If you have questions or comments, contact us. Kimo-support@kimotools.com... -
Page 3: Safety Warnings
SAFETY WARNINGS General power tool safety warnings WARNING: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. - Page 4 users. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Keep cutting tools sharp and clean.
- Page 5 Follow your local regulations relating to disposal of battery. Use the batteries only with the products specified by KIMO. Installing the batteries to non-compliant products may result in a fire, excessive heat, explosion, or leak of electrolyte.
- Page 6 Battery pack LED indicator KIMO battery packs include a fuel gauge which consists of four LED lights that indicate the level of charge remaining in the battery pack.The fuel gauge is an indication of approximate levels of charge remaining in the...
-
Page 7: Charging Indicator
NOTE: 1. Tap the battery indicator button to indicate the remaining battery capacity and automatically turn off after 5 seconds. 2. When charging, 4 LED Lights blink in sequence, and the LED lights are completely off after being fully charged. Charging Indicator Installing and Removing the Battery Pack From the Tool WARNING:... -
Page 8: Tool Components
7. Battery Slide Button 4. Air Inlet 8. Reuasable Collection Bag Blower Function Vacuum Function ACCESSORIES 1. KIMO Cordless Leaf Blower (2-in-1 3. KIMO Charger Sweeper/Vacuum) 4. KIMO 20V Battery 5. 2 × Reusable Collection Bag 2. Blow Tube & White Ring... - Page 9 INSTALLATION AND OPERATION INSTALLING AND OPERATION FOR BLOWER FUNCTION 1. Connect the blow tube to the blower air outlet: Line up the pegs(1) on the inside of the blow tube(3) with the notches(2) of the housing opening as shown in below picture, make sure the installation is firm. (2) Notches of Air Outlet （3）Blow Tube (1) Pegs of White Ring 2.
- Page 10 INSTALLING AND OPERATION FOR VACUUM FUNCTION 1. Connect the blow tube to the air inlet: Line up the pegs(1) on the inside of the blow tube(3) with the notches(2) of the housing opening as shown in below picture, make sure the installation is firm. (2) Notches of Air Inlet （3）Blow Tube (1) Pegs of White Ring 2.
-
Page 11: Warranty
WARRANTY Every KIMO power tool is warranted to the original purchaser only to be free from defects in material and workmanship. Subject to certain exceptions, KIMO will replace any part on an electric power tool that is defective in material or workmanship for a period of 2 years after the date of purchase unless otherwise noted.
Need help?
Do you have a question about the QM-6001 and is the answer not in the manual?
Questions and answers
need charging cord for 20 v max lithium Kimo QM-6001 cordless blower