Electrolux IHGL9030CN User Manual page 6

www.electrolux.com
6
4. CONTROLS
Button
L
T1
T2
T3
T4
T5
F
5. LIGHTING
• For replacement contact tech-
nical support ("To purchase
contact technical support").
L T1 T2 T3 T4 T5 F
Basic function
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate the lighting
system in "courtesy light" mode. The lights are lit at a reduced
power of approximately 5W. This function can be disabled by
pressing the button once again for 2 seconds or by pressing it
briefly to switch to normal lighting mode.
Turns the motor off from whatever speed it is set to.
Press and hold the button for 3 seconds with all the loads turned off
(Motor and Lights), to turn the Activated Charcoal Filter alarm on/off.
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two.
Press and hold the button for approximately 2" to turn the Delay
function on and off, that is to say to turn the appliance off after a
20 minute delay. Suitable to complete elimination of residual odours.
Can be activated from the OFF position and from speeds 1, 2, 3.
Cannot be activated with Intensive speed On.
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a timed
period of 5 minutes. At the end of the 5 minutes the appliance
will automatically return to the speed that was set before. If
the appliance was turned off at the time of activation, at the
end of the 5 minutes the system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm
indicator, shown by flashing of button T1. This procedure
can only be carried out with the motor off.
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on Speed two on
Buttons flashing
(T1+T2 or T3 or
Delay functionActive
T4)
Button on
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it
is necessary to wash the filters.
Button on
The alarm is triggered after the
Hood has been in operation for
100 working hours.
When this is activated, it
signals the Activated Char-
coal Filter saturation alarm,
indicating that the filter must
be changed; the Metal Grease
Button flashing
Filters must also be washed.
The Activated Charcoal Filter
saturation alarm comes into
operation after the Hood has
been working for 200 hours.