Advertisement
The innovative sensor control panel of the Digital Dual-Zone Proximity Sensor IV
makes setting sensitivity for each of the two zones a breeze. The control panel
window has five LEDs: four green LEDs to indicate the 32-step sensitivity level of
each zone, and a red LED on the left to confirm inner zone activation. The last green
LED on the right also doubles as the outer zone activation light that visually
indicates whenever the outer zone senses motion.
Each green LED has 8 different steps to indicate sensitivity setting: OFF, six steps
of slow to rapid flashing, and constant ON. To increase or decrease sensitivity of
either the exterior or interior zone, simply do the following:
1. Select the zone you wish to adjust by sliding the "select zone" knob.
2. Press the minus (–) button once to lower sensitivity one step of the plus
(+) to increase sensitivity. The green LEDs will indicate the change as
noted above.
3. Exit the vehicle and test your new setting. The red inner zone LED
should flash when you lean your body into the passenger compartment,
but should ignore any movement outside the vehicle windows. The green
outer zone LED should flash only when there is movement within about
one foot of the windows.
NOTE: If you can's see the control panel while testing, arm your alarm, wait at
least 10 seconds, then put your hands and face up to the window to see inside
the vehicle. You should get the warning. Lean into the vehicle through an open
window. You should get the full alarm activation.
4. If needed, use the (+) and (–) buttons to make further adjustments, then
retest. If the other zone needs adjustment, repeat steps 1-4.
© Copyright Clifford Electronics, Inc., 1994
31-254A/DPS4OM/1294
Advertisement
