SkyLink MM-318 Manual

3-Button Remote
1. INTRODUCTION
Thank you for your purchase of Skylink® remote transmitter, Model MM-318.
The following items are included in this package:
- One of MM-318 Remote
- Lithium Battery CR-2032 (Installed)
- Mounting accessories
- User's Instructions
Follow one or more instructions below to program transmitter MM-318 to the Skylink® receiver
or Skylink® garage door opener you want to control.
2. PROGRAMMING
2a. PROGRAMMING A REMOTE TRANSMITTER TO THE SKYLINK® GARAGE DOOR
OPENER – ATOMS™ SERIES
1. Connect the opener to an approved power source.
The dot in the LED display stays on.
2. Press the [Set] button for one second, and release the
button until the LED Display shows the letter "P".
3. Within 30 seconds, press any button on the remote
that you would like to program to the opener.
Note:
. ..
[ ] = Button 1, [
4. Once the button on the remote is programmed. The
LED segment will off and emits one beep indicating
the programming successfully
MODEL: MM-318
...
] = Button 2, [
Button [1]
Button [2]
Button [3]
] = Button 3
Preliminary Copy