Advertisement
Model #512
Holds 225 ft. of 5/8" Hose
b a s i c s
™
Wall Mounted Hose Reel with Shelf
Owner's Manual
VISIT OUR WEBSITE: WWW.LIBERTYGARDENPRODUCTS.COM
OR CALL US TOLL FREE AT 1-866-820-5805
LIBERTY GARDEN PRODUCTS, INC.
1161 SOUTH PARK DRIVE, KERNERSVILLE NC 27284
IMPORTANT: READ THE OWNER'S MANUAL BEFORE ASSEMBLING
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Liberty Garden Liberty Basics 512
- Page 1 ™ Wall Mounted Hose Reel with Shelf Owner’s Manual VISIT OUR WEBSITE: WWW.LIBERTYGARDENPRODUCTS.COM OR CALL US TOLL FREE AT 1-866-820-5805 LIBERTY GARDEN PRODUCTS, INC. 1161 SOUTH PARK DRIVE, KERNERSVILLE NC 27284 IMPORTANT: READ THE OWNER’S MANUAL BEFORE ASSEMBLING...
-
Page 2: Pre-Assembly
Stamped Logo IMPORTANT: LAY OUT ALL PARTS AND FASTENERS. MAKE SURE ALL PARTS ARE ACCOUNTED FOR. IF ANY PART IS MISSING PLEASE CONTACT LIBERTY GARDEN PRODUCTS AT 1-866-820-5805. DO NOT CONTACT THE RETAILER. VISIT OUR WEBSITE, WWW.LIBERTYGARDENPRODUCTS.COM OR E-MAIL CUSTOMERSERVICE@LIBERTYGARDEN PRODUCTS.COM FOR MORE INSTRUCTIONS. -
Page 3: Installation
INSTALLATION This hose reel must be mounted to a solid masonry wall or to wall studs. Tip: Remember to use the correct size and quantity of hardware to support the total weight of the unit. A standard 100’ length of garden hose weighs approximately 15 lbs. Filled with water, the additional weight can exceed 20 lbs. The mounting hardware must be able to support the combined weight of the unit, garden hose, plus water. - Page 4 ASSEMBLY 2. Install the side frame (E) onto the upper and lower NOTE: Most parts are assembled by locking tabs on frame bars (F) and (G) as shown. the mating parts. The locking tab must slide down into the snap as shown in the figures below. NOTE: Ensure the locking tabs and snaps engage and an audible snap is heard when the frame bars and side frame are assembled.
- Page 5 ASSEMBLY 5. Align cross brace (A) tabs with right reel side (C) 8. Place the frame on a sturdy surface and install the and assemble as shown. reel asembly on the frame as shown in the figure below. NOTE: Flex the side frames (E) outward to enable installation of the reel assembly.
- Page 6 ASSEMBLY 10. Using lubricant tube (K), lubricate the o-rings on 14. Align shelf (L) tabs with the side frame (E) slots on the supply tube (I). each side and snap into position as shown below. 11. Align the supply tube (I) tabs with the side frame slots and push until the supply tube is fully inserted.
-
Page 7: Care And Maintenance
ASSEMBLY 17. Connect Leader hose (M) to supply tube (I). 18. Connect garden hose to the exit tube (D). NOTE: Do not overtighten the leader hose. NOTE: Do not overtigthen the garden hose. NOTE: Check for leaks prior to mounting. CARE AND MAINTENANCE WINTERIZING AND STORAGE Drain the hose reel prior to the onset of freezing temperatures. - Page 8 To obtain performance under this limited warranty, Customer shall notify Company in writing (to Liberty Garden Products, Inc., 1161 South Park Drive, Kernersville, NC 27284, Attn: Customer Service / Warranty Department), by email (to customerservice@libertygardenproducts.com), or by telephone (to (336) 992-3595) with a full description of the defect that is covered by warranty and a copy of the dated proof of purchase of the applicable product.
- Page 9 LIBERTY GARDEN PRODUCTS LIMITED WARRANTY CONTINUED 2. EXCLUSION AND LIMITATION OF LIABILITY: IN NO EVENT, WHETHER BASED ON CONTRACT OR TORT OR OTHER LEGAL THEORY, SHALL COMPANY BE LIABLE FOR ANY INDIRECT, INCIDENTAL, PUNITIVE, SPECIAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT...
- Page 10 ™ “Liberty” is a registered trademark of Liberty Garden Products, Inc. Kernersville, NC. All Rights Reserved 2018 Updated 12/17/2018...
Need help?
Do you have a question about the Liberty Basics 512 and is the answer not in the manual?
Questions and answers