Advertisement
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Connecting The DWL-1750 Wireless
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
Router/Bridge To Your Network
Step 1:
With the unit powered off, attach the antenna to the antenna connector.
NOTE: Do not over-tighten; tightness by hand is sufficient. Position the antenna for
best signal reception.
Step 2:
Attach the Console Port cable to the Serial Port. Attach the other cable end
to the Serial Port on a PC running a terminal emulation program, and set the terminal
to 115200 Baud, No-Parity, 8 data bits, 1 Stop bit, and ANSI compatible. NOTE:
This connection is required only for setting up initial factory configuration information.
Step 3:
Plug the female end of the power cord into the Inline Power Injector, and
then plug the male end of the power cord into a power outlet or power strip. The
Power LED on the front of the Inline Power Injector will light up.
Step 4:
Run the Cross-Over Ethernet cable (included in your package) from the
Data Input Port (on the
PC
referenced to above.
Step 5:
Plug the
MIL-C-5015 style
on the back of the Router / Bridge.
Step 6:
Plug the RJ-45 Ethernet connector (the other end of the Special Ethernet
cable) into the Power & Data Output Port on the front of the Inline Power Injector.
When the Router / Bridge receives power over the Ethernet cable, the Router / Bridge
will start its boot sequence and the Active LED on the front of the Inline Power
Injector will light up.
Please refer to the product image on pg. 5
1.
Special Ethernet port for connecting the MIL-C-5015 style Ethernet Cable
2.
Special serial port for connecting the MIL-C-5015 style RS-232 console port cable
3.
Reverse polarity-N Male connector for connecting an antenna or RF cable
4.
Power and Data output port for connecting another MIL-C-5015 style Ethernet cable
5.
Data input port for connecting an Ethernet cable to a hub, switch, pc or router
6.
AC power input port for connecting the power cord.
front of the Inline Power Injector) to the Ethernet Port on the
Ethernet connector into the Special Ethernet port
4
Advertisement
