Please read the manual carefully and observe the precautions to prevent and to avoid damages to the equipment, before using the products of Lombardi Amplification. Please keep this manual for future references. information In order to avoid electrical shock do not remove the top cover of the device.
Lombardi’s made in Italy products. The audio amplifier was tested to the limit before it was placed on the market. technical specifications 1KHz, 0.001% THD+N...
A M P L I F I C A Z I O N I front description mounting on RACK regular signal indicator There are two mounting holes in the front When this led is on the amplifier works properly. panel to mount on rack. In the rack the amplifier occupies 2 units.
A M P L I F I C A Z I O N I rear description Handles switch the handles are used to ground switch insert or remove the amplifier from the rack. channel balanced input power supply 1 ground 2 signal (+) 3 phase (-) Two VDE a male one and a female one in order to power and relay the power...
In the rear panel of the amplifier LAST 600S there are 2 separate channels. There is 1 input and 1 output per channel input channel A: XLR panel female connector XLR panel male connector...
Page 8
A M P L I F I C A Z I O N I specific use of inputs mixer 1 ground input A signal 2 signal balanced 3 phase input B mixer signal 1 / 3 - unbalanc cascade connection amplifier specific use of output passive loudspeaker/s input A...
Page 9
A M P L I F I C A Z I O N I cabinet dimension in mm [inch] front 480 [18,9] rear 442 [17,4] lateral 365 [14,37] 425 [16,73] pagina 9 di 10...
Page 10
A M P L I F I C A Z I O N I European Community directives This device is in conformity with the requirements of the relevant European Community directives with regard to the European made in Italy Electromagnetic Compatibility Directive (EMC) 89/336/EC as amended by Directives 92/31/EC and 93/68/EC and the Low Voltage Directive (LVD) 73/23/EC as amended by Directive 93/68/EC.