INTRODUCTION Thank you for purchasing this CRYSTAL CB Radio. Please ensure that you have read the product manual and instructions in full, prior to installation and use. Failure to do so may result in product failure/damage or incorrect operation and therefore impact the product performance.
Page 3
“blasting area” or in areas posted: “Turn off the two way radio.” Obey all signs and instructions. Exposure to Radio Frequency Energy Your CRYSTAL two-way radio complies with Australian Communications Authority Radio communications (Electromagnetic Radiation-Human Exposure) Standard, 2003. To assure optimal radio performance and make sure human exposure to radio frequency electromagnetic energy is within the guidelines set out in the above standards always adhere to the following procedures.
Page 4
Electromagnetic Interference/Compatibility Nearly every electronic device is susceptible to electromagnetic interference (EMI). To avoid the possibility of electromagnetic interference and/or compatibility conflicts, turn off your radio in any location where posted notices instruct you to do so such as health care facilities.
Page 5
INSTALLING THE BATTERY & BELT CLIP Belt clip The supplied belt clip simply slides into the back of the main radio and clicks in place to lock. If fitted, remove the belt clip by lifting the top tab away from the main unit and slide the belt clip up.
Your DBH034PK is simplex “one way at a time”. While you are speaking, you cannot receive a transmission. Your DBH034PK is an open-license band. Always identify yourself when transmitting on the same channel.
Page 8
For others to receive your transmission, they must be on the same channel as you. Squelch control The DBH034PK has automatic squelch control, which silences the constant background noise during periods of inactivity. The radio will still receive transmissions when a signal is present, however it will eliminate background noise when a signal is not present.
Page 9
It is an alternative option from just speaking into the MIC to make the user stand out. The DBH034PK has 10 call tone options. To transmit a call tone, quick press the “(PTT) button”.
Page 10
NOTE: Legislation only allows the call tone to be used once per minute, if the call button is pressed more than once in a minute, the radio simply will not resend the call tone again. Setting Call Tone Press the “(MENU) button” four times, CA will on the LCD. Press the “DOWN button” or “UP button”...
Page 11
Channel 5 and 35 (paired for Duplex repeaters) are reserved as emergency channels and should be used only in an emergency. CTCSS and DCS will not operate on channels 5 and 35. A list of currently authorised channels can be obtained from the ACMA website in Australia and the MED website in New Zealand.
FUNCTION- USING THE UHF RADIO Transmit & receive procedure Your UHF radio contains a transmitter and receiver. To control your exposure and ensure compliance with the general population/uncontrolled environment exposure limits, always adhere to the following procedure: Transmit no more than 50% of the time. To receive calls, release the “(PTT) button”...
Page 13
Radio communications (Citizen Band Radio Stations) Class Licence 2002 No licence is required to own or operate this radio in Australia and New Zealand. The Radio communications (Citizen Band Radio Stations) Class Licence 2002 contains the technical parameters, operating requirements, conditions of licence and relevant standards for Citizen Band (CB) radios.
Page 15
123.0 250.3 127.3 Radio communications (Citizen Band Radio Stations) Technical Assistance If you need assistance setting up or using your CRYSTAL product now or in the future, call CRYSTAL Support. Australia TEL: 03 – 8587 8898 FAX: 03 – 8587 8866 Mon-Fri 9am – 5pm AEST Please retain this user guide for future reference.
Page 16
For latest manuals and updates refer to the website. CRYSTAL MOBILES WARRANTY AGAINST DEFECTS This warranty against manufacturing defects is given by TDJ Australia Pty Ltd ACN 006 385 191). Our contact details are set out in clause 2.7.
Page 17
4. Warranty period 4.1 We provide the following warranty on Crystal Mobile products. No repair or replacement during the warranty period will renew or extend the warranty period past the period from original date of purchase.
Need help?
Do you have a question about the DBH034PK and is the answer not in the manual?
Questions and answers