Power On - D-Link DSS-24 User Manual

DSS-24 10/100 Auto Negotiation Switch User's Guide

Power On

The power supply will adjust to the local power source automatically. The DSS-
24 may be plugged in without having any or with all LAN segment cables
connected.
The power plug is located at the rear of the DSS-24. Plug the cable into the wall
socket and plug the other end into the DSS-24. There is no on/off switch. The
DSS-24 powers on when you plug the power cord into the three pronged power
connector. The Power LED will light when the DSS-24 is powered on. All ports
will automatically negotiate the proper speed and duplex mode.
Reboot the DSS-24 if there is a problem. Contact D-Link Systems, Inc. for
technical support.
After a power failure, it may be necessary to reconfigure any ports that were
manually set. All other ports should automatically negotiate the proper speed and
duplex mode.
The DSS-24 can be used with power sources in the range 100 to 240 VAC., 50 to
60 Hz.
Installing the DSS-16 and DSS-24
11