Advertisement

xmix 802 USB
mixer
user manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the xmix 802 USB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for The t.mix xmix 802 USB

  • Page 1 802 USB mixer user manual...
  • Page 2 Musikhaus Thomann Thomann GmbH Hans-Thomann-Straße 1 96138 Burgebrach Germany Telephone: +49 (0) 9546 9223-0 E-mail: info@thomann.de Internet: www.thomann.de 01.02.2018, ID: 422790...
  • Page 3: Table Of Contents

    1.1 Further information......................4 1.2 Notational conventions....................4 1.3 Symbols and signal words................... 4 Safety instructions......................... 6 Features............................8 Installation and starting up....................9 Connections and controls....................10 Technical specifications....................17 Plug and connection assignment................. 18 Protecting the environment................... 20 xmix 802 USB...
  • Page 4: General Information

    General information General information This manual contains important instructions for the safe operation of the unit. Read and follow the safety instructions and all other instructions. Keep the manual for future reference. Make sure that it is available to all those using the device. If you sell the unit please make sure that the buyer also receives this manual.
  • Page 5 This combination of symbol and signal word indicates a possible dangerous situation that can result in mate- rial and environmental damage if it is not avoided. Warning signs Type of danger Warning – high-voltage. Warning – danger zone. xmix 802 USB...
  • Page 6: Safety Instructions

    Safety instructions Safety instructions Intended use This device is intended to be used for amplification, mixing and playback of signals from musical instruments and microphones. Use the device only as described in this user manual. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage.
  • Page 7 NOTICE! Danger of short circuit Switching on phantom power will damage the device if unbalanced XLR cables are connected. Only turn on phantom power when exclusively balanced XLR cables are connected. xmix 802 USB...
  • Page 8: Features

    Features Features 8-channel mixer 4 mono channels (MIC, line) with 3-band EQ, switchable phantom power and low 2 stereo channels with balance control 1 × AUX control per channel, PRE/POST selectable Master output L/R via 2 × XLR and 2 × 1/4" phone socket (stereo) CTRL room output L/R (1/4"...
  • Page 9: Installation And Starting Up

    PVC floor and after some time cause permanent dark stains. In case of doubt, do not put the rubber feet directly on the floor, but use felt-pad floor protectors or a carpet. xmix 802 USB...
  • Page 10: Connections And Controls

    Connections and controls Connections and controls Mono channel strip 1 [MIC] Balanced XLR mono input to connect a microphone. 2 [LINE] 1/4" phone input to connect a line level audio source (keyboards, drum modules etc., balanced or unbalanced). 3 [80 Hz HPF] High pass filter to attenuate rumble noise and other low frequency interfer- ence.
  • Page 11 When this switch is pressed, the signal portion set with the [AUX]control is not affected by the channel fader ([PRE]). When the switch is not pressed, the AUX signal is not subject to the channel fader ([POST]). 31 [PFL]LED This LED lights on activated PFL function. xmix 802 USB...
  • Page 12 Connections and controls 32 [PEAK] The LED lights up on channel overload. If this happens in channel 9/10 press the [PAD]switch. When overload occurs in channel 11/12 reduce the output level of the signal source connected here. 33 The channel fader sets the strength of the channel signal in the overall signal.
  • Page 13 USB port for feeding in digital audio signals or for digital output of the sum signal, unaffected by the master faders. [CR OUT L] Control room output for connecting amplifiers or active speakers. [CR OUT R] Control room output for connecting amplifiers or active speakers. xmix 802 USB...
  • Page 14 Connections and controls [+48V]LED This LED is lit when the phantom power is on. [+48V]switch When this switch is in ON position, a phantom voltage of 48 V is present at the XLR sockets in the mono channels for using condenser mics. If no condenser mics are used, the switch should be in the OFF position. The phantom voltage must not be switched on if an unbalanced XLR cable is connected to one of the MIC inputs.
  • Page 15 58 IEC chassis plug for mains connection with fuse holder. To replace the fuse, carefully take out the fuse holder with a small screwdriver, replace the defective fuse with a new one of the same type and push the fuse holder back in until it snaps into place. Connection pattern – club gig xmix 802 USB...
  • Page 16 Connections and controls Connection pattern – PC home recording mixer...
  • Page 17: Technical Specifications

    Operating supply voltage 100 – 240 V 50/60 Hz Fuse 5 mm × 20 mm, 1.6 A, 250 V, slow-blow Power consumption 40 W Dimensions (W × H × D) 265 × 100 × 340 mm Weight 3.2 kg xmix 802 USB...
  • Page 18: Plug And Connection Assignment

    Plug and connection assignment Plug and connection assignment Introduction This chapter will help you select the right cables and plugs to connect your valuable equipment in such a way that a perfect sound experience is ensured. Please note these advices, because especially in ‘Sound & Light’ caution is indicated: Even if a plug fits into the socket, an incorrect connection may result in a destroyed power amp, a short circuit or ‘just’...
  • Page 19 Ground, shielding Signal (in phase, +) Signal (out of phase, –) XLR plug (unbalanced) Ground, shielding Signal Bridged to pin 1 RCA connection Drawing and table indicate the pin assignment of an RCA plug. Signal Ground, shielding xmix 802 USB...
  • Page 20: Protecting The Environment

    Protecting the environment Protecting the environment Disposal of the packaging material For the transport and protective packaging, environmentally friendly materials have been chosen that can be supplied to normal recycling. Ensure that plastic bags, packaging, etc. are properly disposed of. Do not just dispose of these materials with your normal household waste, but make sure that they are collected for recycling.
  • Page 21 Notes xmix 802 USB...
  • Page 22 Notes mixer...
  • Page 24 Musikhaus Thomann · Hans-Thomann-Straße 1 · 96138 Burgebrach · Germany · www.thomann.de...

Table of Contents