Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Zoo Fans H65-EC
- Page 1 Installation Guide Models: H65-EC Covered by the following United States and International Patents: D631148S, 138172, 001790452-001, 338608 and other patents pending 1650 38 St, Suite 201W Boulder, CO 80301 (303) 557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017...
- Page 2 WARNING: To prevent electrical shock and/or injury disconnect fan from power source before you move or service the fan. Not Suitable for use with solid-state speed controls. WARNING: To reduce the risk of fire, electric shock, and injury to persons, ZOO Fans must be installed only with controllers supplied by ZOO Fans. Other parts cannot be substituted.
- Page 3 AVERTISSEMENT : Restez vigilent, faites attention à ce que vous faites, et faites preuve de bon sens lors de l’installation de ventilateurs ZOO Fans. N’installez pas de ventilateurs si vous êtes fatigué ou sous l’influence de drogues, d’alcool ou de médicaments.
-
Page 4: Table Of Contents
OPTION 2 - Wiring 0 – 10VDC Analog Signal ........................9 OPTION 3 - Wiring MODBUS Control Signal ......................... 9 STEP 4: START-UP AND COMMISSIONING ..........................10 1650 38 St, Suite 201W Boulder, CO 80301 (303) 557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 10042017... -
Page 5: Pre-Installation
PRE-INSTALLATION The safe installation and operation of equipment supplied by ZOO Fans is the responsibility of the system designer, installer, maintainer, and operator (collectively, the “User”). The need for protective safety accessories to meet company standards, applicable codes, and the requirements of the Occupational Safety and Health Act (“OSHA”) must be determined by the User since safety requirements may vary depending on the location and application of the equipment. -
Page 6: Zoo Fans Specifications
You may also contact your ZOO Fans’ representative or ZOO Fans directly if you require assistance. Remember, the number of ZOO Fans required for the job, as well as where they are hung, will depend on a number of variables, some of which are: •... -
Page 7: Installation
The fan intake must be 12” from any obstruction. ZOO Fans are designed to be hung vertically or at an angle. For vertical installations, proceed to STEP 1 below. To install the ZOO Fan at an angle, additional hardware is required. Please contact ZOO Fans or your ZOO Fans’... -
Page 8: Step 2: Fasten Stabilization Tether
2. Insert 1/4” Hex Head bolt through the hole located at 45° on either side of the handle 3. Securely tighten 1/4” Nylock Nut Illustration 2 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 05182017... -
Page 9: Step 3: Secure The Gripples
2. Loop cable over Truss, I-Beam, or support beam 3. Insert end of cable into Gripple 4. Adjust to desired height Illustration 3 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 05182017... - Page 10 4. Adjust cable so there is no slack 5. Excess cable should be neatly rolled up and taped or cut for a clean installation Illustration 4 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 05182017...
-
Page 11: Wiring The Fan
Single Phase installation ONLY 208V – 277V 50Hz or 60Hz Alternatively, these motors will accept DC voltage. Please contact Zoo Fans for details. • Electrical connection should be made according to Illustration 8, the wiring diagram below: Illustration 8, Wiring Diagram... -
Page 12: Step 3: Wiring The Control Signal
STEP 3: WIRING THE CONTROL SIGNAL The H65-EC has multiple control options available including: 10k Ohm Potentiometer 0 – 10 Volt DC analog signal PWM signal (contact Zoo Fans for wiring instructions) MODBUS RS-485 (must be preconfigured at factory) WARNING: Never apply line voltage to the digital input Contact Zoo Fans for other control options. -
Page 13: Option 2 - Wiring 0 - 10Vdc Analog Signal
OPTION 2 - Wiring 0 – 10VDC Analog Signal Illustration 10 OUTPUT (0-10VDC) OPTION 3 - Wiring MODBUS Control Signal Illustration 11 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 05182017... -
Page 14: Step 4: Start-Up And Commissioning
WARNING: Never apply line voltage to the digital input ZOO Fans 1650 38 St. Suite 201W Boulder, CO 80301 Phone: 303.557.1852 Fax: 859.765.0027 customerservice@zoofans.com zoofans.com 1650 38 St, Suite 201W Boulder, CO 80301 PHONE: 303-557-1852 zoofans.com ©2017 ZOO FANS INC. ALL RIGHTS RESERVED REV 05182017...
Need help?
Do you have a question about the H65-EC and is the answer not in the manual?
Questions and answers