Related Manuals for Everdure HUB
Summary of Contents for Everdure HUB
- Page 1 Assembly, Operation & Maintenance Instructions Assembly, operation & maintenance instructions for Everdure by Heston Blumenthal HUB™ electric ignition charcoal barbeque everdurebyheston.com 800065...
- Page 2 Inspired by the past. Innovated for the future. T H E O U T D O O R P E R F O R M A N C E...
-
Page 3: Table Of Contents
OPERATION AND MAINTENANCE INSTRUCTIONS FOR HBCE2BUS ELECTRIC IGNITION CHARCOAL BARBEQUE RANGE Everdure by Heston Blumenthal outdoor charcoal barbeques. It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Everdure by... -
Page 4: Important Safety Instructions
(and void the warranty). Regular 8. If the power cord is damaged, it must be replaced by the manufacturer, an authorised cleaning and covering with an Everdure by Heston Blumenthal HUB barbeque cover service centre or similarly qualified persons to avoid a hazard. - Page 5 26. Do not use volcanic rock or any type of non-combustible product in the charcoal unit according to the use and care manual, ensuring you provide good ventilation when chamber. If in doubt on what fuels can be used, check the Everdure by Heston cooking with gas.
- Page 6 Assembly, Operation & Maintenance Instructions DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE DO NOT OPERATE THIS APPLIANCE INDOORS DO NOT OPERATE THIS APPLIANCE IN ENCLOSED AREAS DO NOT USE ACCELERANTS OR FUEL IMPREGNATED WITH ACCELERANTS IN THIS APPLIANCE DO NOT OVERFILL THE CHARCOAL CHAMBER AT IGNITION...
-
Page 7: Appliance Details
Assembly, Operation & Maintenance Instructions APPLIANCE DETAILS ELECTRICAL:120V AC, 60HZ, 1400W, IPX4 Barbeque only LENGTH WIDTH HEIGHT (ft) (ft) (ft) NOTE: Fully extended, the rotisserie poles increase the height by 6.7in (170 mm) -
Page 8: Operating Instructions
For more specific information (including set-up illustrations and diagrams) and up to date cooking instructions, please visit the Everdure by Heston Blumenthal website at ROTISCOPE TECHNOLOGY www.everdurebyheston.com. -
Page 9: Ignition Procedure
Assembly, Operation & Maintenance Instructions IGNITION PROCEDURE audible sound and LED will indicate this has turned on). Adjust charcoal to suit the food being cooked. Do not leave the appliance cooking for extended periods of time unattended. As food READ ALL OPERATING INSTRUCTIONS BEFORE IGNITING THE cooks on the rotisserie, fat can drip off causing flare-ups which can spoil food. -
Page 10: Cleaning & Storage
When the appliance is not in use, the barbeque can be stored outdoors, but must be under EXTERNAL CLEANING cover and covered (preferably with a purpose made HUB Barbeque cover), out of the weather. Ensure the cooking surface is clean before storing away. Do not leave the power Before cleaning the barbeque exterior, ensure the appliance has cooled and is safe to cord connected to the power supply for extended periods of time (disconnect after use). -
Page 11: Troubleshooting
Assembly, Operation & Maintenance Instructions TROUBLESHOOTING Solid fuel is not igniting or taking longer than expected to ignite: Power supply interrupted Check the LED at the ignition switch is lighting when pressed. Check cord is connected & turned on. Check power is being supplied to appliance (power outage or tripped circuit breaker). -
Page 12: Barbeque Assembly
Open the carton and remove the parts (Note that the barbeque chassis assembly is heavy and will require at least 2 people to move). Remove all packaging (especially check inside the barbeque and under the charcoal grid) and place parts on a clean surface. Check for any damage or missing parts (if found, contact your service department). INCLUDED PARTS HUB 01/ Barbeque Chassis... - Page 13 Assembly, Operation & Maintenance Instructions STEP 01 STEP 02 / Take the Ø4mm spring washers (F03) and Ø0.2in (4mm) washers (F04) and place them / Rotate the barbeque chassis assembly (01) onto its rear panel and lay on a clean flat onto two M4x0.4in (10mm) screws (F01).
- Page 14 Assembly, Operation & Maintenance Instructions STEP 04 STEP 06 / If not already assembled, lever up the element and place the heat shield (09) inside the / Place the left hand open grill (10) and right hand open grill (11) on the twelve pins on the bowl.
-
Page 15: Maintenance
Assembly, Operation & Maintenance Instructions STEP 08 STEP 10 / To extend the rotisserie poles, first press and release them so the first section pops out / With the barbeque in a secure position, fully extend the power cord from the recess on from the barbeque. -
Page 16: Parts List: Barbeque Assembly
Assembly, Operation & Maintenance Instructions PARTS LIST: HBCE2BUS Rotisserie Fork Rotisserie Rod PART NAME Lid Handle Foot Front Inner Pole Assembly Left Hex Bolt M6x0.5in (12mm) Left Open Grill Leg Upper Right Front Outer Pole Assembly Foot Rear Charcoal Grid Leg Upper Right Rear Charcoal Chamber Chassis Right Hand Side Panel... - Page 17 Assembly, Operation & Maintenance Instructions Thermostat Castor Leg Front Cabinet Top Panel Cabinet Side Panel Cabinet Shelf Door Inner Panel Door Upper Hinge Left Hand Door Right Hand Door Door Handle Door Lower Hinge Lockable Castor PCB Top Cover PCB Bottom Cover PCB Mounting 47 44 58 59 60 61...
-
Page 18: Barbeque Accessories
Assembly, Operation & Maintenance Instructions OPTIONAL ACCESSORY: COOKING ACCESSORIES Please see www.everdurebyheston.com for a full range of accessories... - Page 19 Assembly, Operation & Maintenance Instructions...
- Page 20 IM Ref: HUBUS 12/2017/01 FOR OUTDOOR USE ONLY eve rd u re byh e s to n .c o m...
Need help?
Do you have a question about the HUB and is the answer not in the manual?
Questions and answers