Summary of Contents for MYE MWCS-AT9-MXA
- Page 1 MWCS-AT9-MXA MYE 900MHz (Wireless) CableSAT For attached Matrix 15” TVs and 7Xe Embedded TVs MYE Entertainment 1-661-964-0217 www.myeclubtv.com All Rights Reserved 2016...
- Page 2 Transmitter Installation 1. Remove the Matrix rear cover on the TV. 2. Disconnect the Matrix controller cable going from the console to the TV. 3. Plug the controller cable into the CableSAT transmitter “Control In.” 4. Plug one end of the MCC-X cable into the CableSAT “Out.” 5.
- Page 3 Receiver Installation Connecting the receiver to the SET TOP BOX can be achieved by ONE of the two options. OPTION 1: Plug the MWCS-IR emitter cable into the receiver and attach the IR emitter to the Set Top Box IR window. OPTION 2: ALIGN THE RECEIVER’S IR WINDOW WITH THE SET TOP BOX IR @@@@@WINDOW To MACA-9V power...
- Page 4 ***Once the receiver is installed you can select your Set Top Box (below). Unit is shipped in AT&T mode. Match the lit LEDS to your Set Top Box type. 1) Start with the CableSAT Receiver power disconnected. 2) Using a pen or paperclip, press and hold the “PGM” switch. 3) Connect power to CableSAT Command Receiver.
- Page 5 WARRANTIES GIVEN ABOVE FOR THOSE SAME PARTS. MYE HEREBY DISCLAIMS AND EXCLUDES THOSE WARRANTIES THEREAFTER. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. MYE ENTERTAINMENT ALSO...
Need help?
Do you have a question about the MWCS-AT9-MXA and is the answer not in the manual?
Questions and answers