CONTENTS Safety information Settings Safety instructions Before first use Product description Daily use Control panel Hints and tips Programme Chart Care and cleaning Consumption values Troubleshooting Options Technical Data Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions.
Do not exceed the maximum load of 9 kg (refer to the • "Programme chart" chapter). The operating water pressure at the water entry point from • the outlet connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa). The ventilation opening in the base must not be covered •...
Page 4
Service Centre to ensure which centre for the other drain hose and the accessories can be used. extension. Electrical connection • The appliance must be earthed. WARNING! Risk of injury, • Always use a correctly installed electrical shock, fire, burns or shockproof socket.
PRODUCT DESCRIPTION Appliance overview Worktop Detergent dispenser Control panel Door handle Rating plate Feet for levelling the appliance CONTROL PANEL Control panel description Kurz / 1400 90° Buntwäsche / Coton Rapide Buntwäsche / Coton Intensiv / 60° 1200 Intensif Ende in / Fini dans Pflegeleicht / Synthétiques Bügelquick / 40°...
Door locked indicator Display A. The time area: • : the programme duration • : the "finish in" time • : the alarm codes • : the message of error Ende in / Fini dans • : the programme is completed. B.
Page 7
Programme Maximum Programme description Temperature load (Type of load and soil level) range Maximum spin speed Daunen/Couette 3 kg Special programme for one synthetic blanket, du‐ 60 °C - Cold 800 rpm vet, bedspread and so on. Mix 20°/ 2 kg Special programme for cotton, synthetic and mixed Programme Mix 1200 rpm...
Programmes Load Energy Water Approxi‐ Remain‐ (kg) consump‐ consump‐ mate pro‐ ing mois‐ tion (kWh) tion (litre) gramme ture (%) duration (minutes) Buntwäsche/Coton 1,58 60°C Buntwäsche/Coton 1,01 40°C Pflegeleicht/ 0,74 Synthétiques 40°C Feinwäsche/Déli‐ 0,54 cats 40°C Wolle/Laine 0,42 30°C Standard cotton programmes Standard 60°C cot‐...
Page 10
• Set this option to deactivate all spin The related indicator comes on. phases. Only the drain phase is Spülen/Rinçage seul available. • The related indicator comes on. With this option you can perform only a • Set this option for very delicate fabrics. last rinse of a selected washing •...
SETTINGS Extra Rinse This option stays active even when you switch off the With this option you can permanently have appliance. an extra rinse when you set a new programme. Acoustic signals • To activate/deactivate this option The acoustic signals operate when: touch the buttons at the •...
Page 12
Detergent compartments CAUTION! Make sure that no laundry stays between the seal Detergent compartment for and the door. There is a risk of washing phase. water leakage or damage to If you use liquid detergent, put the laundry. it immediately before you start Washing heavily oiled, greasy the programme.
Page 13
• Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid then the maximum level. • Do not set the delay start (or Finish in option). Activating the appliance Starting a programme without the Ende in/Fini dans option...
Page 14
The display shows the number of hours 2. Press the same button again to activate the appliance. Now, you can you set (e.g. ) and the indicator above set a new washing programme. the button is on to show that his option Before starting the new is active.
• Keep the door and the detergent 2. Press the button for some seconds drawer ajar, to prevent the mildew and to deactivate the appliance. odours. The appliance drains and spins The washing programme is completed, automatically after but there is water in the drum: approximately 18 hours (except •...
Special stain removers are available. Use dosing ball (supplied by the detergent's the special stain remover that is applicable manufacturer). to the type of stain and fabric. Ecological hints Detergents and additives • Always start a washing programme • Only use detergents and additives with the maximum load of laundry specially made for washing machines: allowed.
Page 17
Door seal Regularly examine the seal and remove all objects from the inner part. Cleaning the detergent dispenser...
Page 18
Cleaning the inlet hose and the valve filter 45° 20° Frost precautions If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Do this procedure also when you want to do the emergency 5.
TROUBLESHOOTING WARNING! Refer to Safety chapters. Introduction The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the table). If the problem persists, contact the Authorised Service Centre. With some problems, the acoustic signals operate and the display shows •...
Page 20
Problem Possible solution The appliance does not • Make sure that the water tap is open. fill with water properly. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. •...
Problem Possible solution The appliance fills with • Make sure that the drain hose is in the correct position. The water and drain immedi‐ end of the hose may be too low. Refer to 'Installation instruc‐ ately. tion'. The cycle is shorter than •...
Page 22
WARRANTY / CUSTOMER SERVICE For each product we provide a two-year guarantee will lapse if the operating guarantee from the date of purchase or instructions and conditions of use are not delivery to the consumer (with a adhered to, if the product is incorrectly guarantee certificate, invoice or sales installed, or in the event of damage receipt serving as proof).
Page 23
Our customer service telephone number: 0848 559 111 oder unter ou sur Internet oppure su Internet or in the internet www.fust.ch Dipl. Ing FUST AG Dipl. Ing. FUST AG Dipl. Ing. FUST AG Ing. dipl. FUST SA Buchental 4 Riedmoosstrasse Schneckelerstrasse 1 Hyper-Fust Romanel Centre 9245 Oberbüren...
Need help?
Do you have a question about the NOVAMATIC WA914.1 E and is the answer not in the manual?
Questions and answers