Table of Contents
Advertisement
UNPACKING CARTON (See Fig. 2)
CAUTION: Be careful of exposed sta ples
when handling or disposing of carton-
ing material.
IMPORTANT:
WHEN UN PACK ING AND AS SEM BLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLES.
•
While holding handle assembly, cut cable ties se cur ing
handle assembly to top frame. Let handle assembly
rest on tiller.
•
Remove top frame of carton.
•
Slowly ease handle assembly up and place on top of
carton.
•
Cut down right hand front and right hand rear cor ners
of carton, lay side carton wall down.
•
Remove packing material from handle assembly.
•
Separate shift rod from handle assembly.
HANDLE
ASSEMBLY
INSTALL HANDLE (See Figs. 3, 4, and 5)
•
Insert one handle lock (with teeth facing outward) in
gearcase notch. (Apply grease on smooth side of
handle lock to aid in keeping lock in place until handle
assembly is lowered into position.)
HANDLE ASSEMBLY
(VIEWED FROM R.H. SIDE OF TILLER)
•
Grasp handle assembly. Hold in "up" position. Be
sure handle lock remains in gearcase notch. Slide
handle assembly into position.
ASSEMBLY
SHIFT ROD
Fig. 2
GEARCASE NOTCH
HANDLE LOCK
Fig. 3
LOOSEN HANDLE LOCK
LEVER TO MOVE
•
Rotate handle assembly down. Insert rear carriage
bolt first, with head of bolt on L.H. side of tiller and
loosely assemble locknut (See Fig. 5).
SLOT
HANDLE
BASE
REAR
CARRIAGE
BOLT
GEARCASE
•
Insert pivot bolt in front part of plate and tighten.
•
Cut down remaining corners of carton and lay panels
flat.
•
Lower the handle assembly. Tighten nut on carriage
bolt so handle moves with some resistance. This will
allow for easier adjustment.
•
Place flat washer on threaded end of handle lock le ver.
•
Insert handle lock lever through handle base and
gearcase. Screw in handle lock lever just enough to
hold lever in place.
•
Insert second handle lock (with teeth inward) in the
slot of the handle base (just inside of washer).
•
Raise handle assembly to highest position and se cure ly
tight en handle lock lever by rotating clockwise. Leav-
ing han dle assembly in highest position will make it
easier to connect shift rod.
6
HANDLE ASSEMBLY
"UP" POSITION
TIGHTEN HANDLE
LOCK LEVER TO
HOLD
Fig. 4
HANDLE LOCK
FLAT
WASHER
LOCKNUT
Fig. 5
HANDLE
LOCK
LEVER
PIVOT
BOLT
Advertisement
Table of Contents
