Koch ALDUP/40 Series User Manual page 4

User manual
Settings
Switch on
Programming mode
Setting the ring tones
Ring tone for Entrance 1 (AS 0)
Ring tone for a Landing call
Ring tone for Internal call
Ring tone for Entrance 2 (AS 1-63)  Press the Talk button repeatedly until you hear the ring tone
Note
Switch off
Programming mode
 Press the Function button
a brief beep
 The red and green LEDs will flash on the monitor
 Programming mode switched on
 Switch on the programming mode (see above)
 Press Talk button
 The red and green LEDs will flash on the monitor
 Press the Unlock door repeatedly until you hear the ring
tone you require
 Press the Function button
ring tone you require
 Press the Display button
tone you require
you require
 The ring tones can be set in succession once the
programming mode has been activated
 If a button has not been pressed for 8 sec, the
programming mode will switch off automatically
 A beep sounds; the red and green LEDs go out
 Programming mode switched off
4/4
○
for approx. 8 until you hear
○
repeatedly until you hear the
□
repeatedly until you hear the ring